HP P6300 HP Y-cable Replacement Instructions (593098-001, June 2011)
HP P6300 Manual
View all HP P6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP P6300 manual content summary:
- HP P6300 | HP Y-cable Replacement Instructions (593098-001, June 2011) - Page 1
HP P6500 EVA Controller Y-cable Replacement Instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are - HP P6300 | HP Y-cable Replacement Instructions (593098-001, June 2011) - Page 2
enclosure port (P1 or P2). 5. Remove the end of the cable that is connected to the second port (cable head P2 (DP 2) in Figure 1.) 6. Insert the new cable end into the disk enclosure port (P1 or P2). Verifying proper operation Use HP P6000 Command View to verify that the device ports are enabled
HP P6500 EVA Controller
Y-cable Replacement Instructions
© Copyright 2011 Hewlett-Packard Development Company, L.P.
First edition: May 2011
The information in this document is subject to change without notice.
Printed in Puerto Rico
www.hp.com
*593098-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/
man
uals
, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY INFORMATION
To obtain a copy of the warranty for this product, see the warranty
information website:
h
t
tp://w
w
w
.hp
.co
m/go/s
t
o
r
age
w
ar
r
an
t
y
Before you begin
Observe the following precautions when replacing the Y-cable:
•
Ensure that the array is either operational and stable on the redundant
path for the device ports being serviced or the array has been shut
down.
•
Label the replacement cable before installing it. See
Labeling the re-
placement Y-cable
.
NOTE:
The Y-cable is replaced as part of the troubleshooting process
to address a communication failure.
Labeling the replacement Y-cable
Before you remove the cable, label the replacement cable with the port
numbers using the label kit that shipped with the cable. Four sheets of
labels (two red and two green) contain all the port numbers you need.
Label the new cable to match the port labels on the original cable.
The replacement cable should resemble
Figure 1
.
Page 1