HP P6300 HP StorageWorks Disk enclosure front power UID interconnect board rep
HP P6300 Manual
View all HP P6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP P6300 manual content summary:
- HP P6300 | HP StorageWorks Disk enclosure front power UID interconnect board rep - Page 1
front power UID interconnect board replacement instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are - HP P6300 | HP StorageWorks Disk enclosure front power UID interconnect board rep - Page 2
from the rack to prevent injury. 5. Remove hard drives from the enclosure. Press the release button on the drive lever (1), and rotate the lever to the left (2). Then, pull and remove the disk drive out of the drive bays (3). Verifying component failure Check for improper or failed operation of - HP P6300 | HP StorageWorks Disk enclosure front power UID interconnect board rep - Page 3
the bezel. c. Remove the piece of tape securing the cable to the drive cage. d. Disconnect the cable from the interconnect board. Installing the power UID interconnect board 1. Secure the power UID interconnect board. a. Connect the replacement cable to the replacement interconnect board. b. Secure - HP P6300 | HP StorageWorks Disk enclosure front power UID interconnect board rep - Page 4
the enclosure in the rack, making sure to tighten the front bezel thumbscrews. Returning the failed component Follow instructions shipped with the replacement part. Additional information HP support: http://www.hp.com/support HP support documentation: http://www.hp.com/support/manuals Page 4
HP StorageWorks
Disk enclosure front power UID
interconnect board replacement
instructions
This document details the procedures for replacing a
failed power UID (Unit ID) module in an HP storage
enclosure.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
First edition: June 2009
The information in this document is subject to change without notice.
Printed in the US
www.hp.com
*504216-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/
man
uals
, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website:
h
t
tp://w
w
w
.hp
.co
m/
go/s
t
o
r
age
w
ar
r
an
t
y
.
Before you begin
Observe the following precautions when replacing a module.
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
NOTE:
Illustrations in this document may show modules or a chassis
that differ from your device. However, replacement procedures
are the same for all chassis that use this component.
Page 1