HP P6300 HP StorageWorks disk enclosure VRM replacement instructions (504218-0
HP P6300 Manual
View all HP P6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP P6300 manual content summary:
- HP P6300 | HP StorageWorks disk enclosure VRM replacement instructions (504218-0 - Page 1
HP StorageWorks Disk enclosure VRM replacement instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are - HP P6300 | HP StorageWorks disk enclosure VRM replacement instructions (504218-0 - Page 2
green to amber. 4. Remove all cabling from the rear of the enclosure. Ensure all cabling is marked to facilitate re-cabling later. WARNING! A disk enclosure fully populated is heavy. Prior to removing the enclosure from the rack, remove each disk and label it with its bay number. Place each disk on - HP P6300 | HP StorageWorks disk enclosure VRM replacement instructions (504218-0 - Page 3
9. Disconnect the VRM cables from the backplane. Installing the VRM 1. Thread the VRM cables through the opening in the chassis and then align the replacement VRM on the guide posts on the bottom of the chassis and top of the power supply cage. 10. Loosen the thumbscrew (T-15 may be needed) - HP P6300 | HP StorageWorks disk enclosure VRM replacement instructions (504218-0 - Page 4
to mark the drives. NOTE: The cables are keyed and are different in size, to the disk enclosure, to ensure that the storage is instructions shipped with the replacement part. Additional information HP support: http://www.hp.com/support HP support documentation: http://www.hp.com/support/manuals
HP StorageWorks
Disk enclosure VRM replacement
instructions
This document details the procedures for replacing a
failed VRM (voltage regulator module) in an HP storage
enclosure.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
First edition: June 2009
The information in this document is subject to change without notice.
Printed in the US
www.hp.com
*504218-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/
man
uals
, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website:
h
t
tp://w
w
w
.hp
.co
m/
go/s
t
o
r
age
w
ar
r
an
t
y
Before you begin
Observe the following precautions when replacing a module.
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
NOTE:
Information is also available on hood label.
NOTE:
Illustrations in this document may show modules or a chassis
that differ from your device. However, replacement procedures
are the same for all chassis that use this component.
The VRM is located inside the enclosure chassis.
Page 1