HP ProLiant 2500 Compaq ProLiant 2500 Family of Servers Maintenance and Servic - Page 29
Replacing Hot-Pluggable Hard Drives, MSG030.EPS
View all HP ProLiant 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
2-16 Removal and Replacement Procedures Replacing Hot-Pluggable Hard Drives The front access drive bay area is behind the front bezel door and can hold up to four or five third-height hot-pluggable hard drives, depending on the optional drive cage. C B A MSG030.EPS Figure 2-13. Removing a Hot-Pluggable Hard Drive 1. Press the releases on the ejector levers [A] and swing levers out [B] as shown. This will pull the drive out of the backplane connector. 2. Slide the hot-pluggable hard drive out [C]. Be sure ejector levers are in the full open position to insure a correct latch MSG-031.EPS while installing. Figure 2-14. Replacing a Hot-Pluggable Hard Drive Ejector lever must latch behind the front panel of the unit.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
2-16
Removal and Replacement Procedures
Replacing Hot-Pluggable Hard Drives
The front access drive bay area is behind the front bezel door and can hold up to four or
five third-height hot-pluggable hard drives, depending on the optional drive cage.
MSG030.EPS
A
B
C
Figure 2-13.
Removing a Hot-Pluggable Hard Drive
1.
Press the releases on the ejector levers [A] and swing levers out [B] as shown.
This will pull the drive out of the backplane connector.
2.
Slide the hot-pluggable hard drive out [C].
MSG-031.EPS
Ejector lever
must latch
behind the
front panel
of the unit.
Be sure ejector levers are in the full
open position to insure a correct latch
while installing.
Figure 2-14.
Replacing a Hot-Pluggable Hard Drive