HP ProLiant DL288 HP SATA DVD-ROM Optical Drive Installation Instructions for
HP ProLiant DL288 Manual
 |
View all HP ProLiant DL288 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP ProLiant DL288 manual content summary:
- HP ProLiant DL288 | HP SATA DVD-ROM Optical Drive Installation Instructions for - Page 1
DVD-ROM Optical Drive Installation Instructions for HP ProLiant servers Overview This document provides instructions for installing the HP SATA DVD-ROM optical drive. The HP SATA DVD-ROM optical drive provides optical media read capability for HP ProLiant servers. The primary purpose of the drive - HP ProLiant DL288 | HP SATA DVD-ROM Optical Drive Installation Instructions for - Page 2
installation guide may result in hazardous radiation exposure. To reduce the risk of exposure to hazardous radiation: • Do not try to open the module enclosure. There are no user-serviceable components inside. • Do not operate controls AC adapter provided by HP. Compliance with these directives
-
1 -
2
 |
 |
HP SATA DVD-ROM Optical
Drive
Installation Instructions
for HP ProLiant servers
Overview
This document provides instructions for installing the HP SATA
DVD-ROM optical drive.
The HP SATA DVD-ROM optical drive provides optical media read
capability for HP ProLiant servers. The primary purpose of the drive is
data access.
For more information about this product, see the HP website
Installing the drive
CAUTION:
To prevent damage to electrical components,
properly ground the server before beginning any
installation procedure. Improper grounding can cause
electrostatic discharge.
For more information on installing the drive in a specific server, see the
documentation provided with the server.
To install the component:
1.
Power down the server as indicated in the server-specific user
documentation.
2.
Disconnect the power cord from the power supply to remove
power from the server and all peripheral devices.
3.
Remove components that prevent access to the removable-media
drive bays.
4.
Install the drive.
5.
If needed, secure with the appropriate fasteners.
6.
Install all components removed from the server.
7.
Connect the power cord to the server, and then connect it to a
properly grounded electrical outlet.
8.
Power up the server.
© Copyright 2007, 2011 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Bluetooth is a trademark owned by its proprietor and used by Hewlett-Packard
Company under license.
Part Number: 453281-003
June 2011
Edition: 3
*453281-003*
453281-003