HP R12000XR HP UPS R/T3000 Installation Instructions

HP R12000XR Manual

HP R12000XR manual content summary:

  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 1
    up to a maximum of 3300 VA/3000 W (these numbers might vary by model). For more information about any of the topics covered in this document, see the UPS user guide located on the documentation CD or HP website (http://www.hp.com/go/rackandpower). Precautions WARNING: To prevent personal injury
  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 2
    as the use of power strips. • Electrical requirements-All models require a dedicated (unshared) branch circuit, suitably rated for the specific UPS as stated in "Input specifications" in the user guide. Readying the equipment 1. Check the battery recharge date specified on the label that is affixed
  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 3
    NOTE: If preparing the rails for integrated shipping, follow the same instructions as in "Installing the UPS ("Installing the UPS in a rack" on page 3)." NOTE: Mounting hardware for square- and round-holed racks is included in the UPS kit. 1. Loosen the wing nuts or hex nuts, and then extend the
  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 4
    to populate the rack from the bottom to the top. 1. Install the mounting rails ("Installing the mounting rails" on page 2). 2. Install the mounting ears on the chassis using the screws provided. Connecting the battery leads Attaching the UPS front bezel 3. With one person on each side, lift
  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 5
    attached to a single, normally-open contact in a parallel connection. HP recommends using different colors for the positive and negative wires. If a " in the user guide. For information about verifying the REPO connection, see "Verifying the REPO port connection" in the user guide. Connecting the
  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 6
    model management software. • number of amps by the selected output voltage to determine the VA. Charging the UPS batteries With the UPS in Standby mode, allow the batteries to charge before putting the UPS into service. IMPORTANT: Charge the batteries for at least 24 hours before supplying backup
  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 7
    Connecting the battery leads WARNING: To reduce the risk of personal injury or logo badge, rotate it 90 degrees, and then replace it in the bezel. Continuing the installation To continue the UPS installation, follow the instructions starting with "Connecting the serial communications port (on
  • HP R12000XR | HP UPS R/T3000 Installation Instructions - Page 8
    Installing the extension bars (if included) Connecting and securing the power cords
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

HP UPS R/T3000
Installation Instructions
Overview
The HP UPS R/T3000 features a 2U rack-mount with convertible
tower design and offers power protection for loads up to a maximum
of 3300 VA/3000 W (these numbers might vary by model).
For more information about any of the topics covered in this
document, see the UPS user guide located on the documentation CD
).
Precautions
WARNING:
To prevent personal injury from earth
conductor leakage current:
Do not operate the UPS while disconnected from the
utility power source.
Disconnect load devices before disconnecting the UPS
from the utility power source.
37 kg
82 lb
This symbol indicates that the UPS exceeds the
recommended weight for one individual to handle
safely.
WARNING:
To reduce the risk of personal injury
or damage to the equipment, observe local
occupational health and safety requirements and
guidelines for manual material handling.
Kit contents
Important Safety Information
guide
This document and/or documentation CD
HP Infrastructure Management Pack CD
To download the latest software version, see the HP website
).
© Copyright 2009 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Part Number 507933-001
January 2009 (First Edition)