HP RP36000/3 HP 3 Phase UPS Parallel Configuration Installation Instructions
HP RP36000/3 Manual
 |
View all HP RP36000/3 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP RP36000/3 manual content summary:
- HP RP36000/3 | HP 3 Phase UPS Parallel Configuration Installation Instructions - Page 1
any of the topics covered in this document, see the UPS user guide located on the documentation CD or HP website (http://www.hp.com/go/rackandpower). Precautions Save these instructions. This document contains important safety instructions that should be followed during installation, operation, and - HP RP36000/3 | HP 3 Phase UPS Parallel Configuration Installation Instructions - Page 2
user guide for HP authorized service redundancy. The UPS models in a parallel configuration require a dedicated branch circuit that meets the following requirements: • Circuit with overcurrent protection, depending on parallel configuration: Number of UPSs in parallel HP 3 Phase NA HP 3 Phase INTL - HP RP36000/3 | HP 3 Phase UPS Parallel Configuration Installation Instructions - Page 3
UPS above the wireway. See "Replacing the UPS" in the user guide. 2. Remove the eight screws on the wireway top cover and on any HP 3 Phase UPS. See the wireway label. Wire gauge depends on overcurrent protection rating required. For more information, see "Installing in a parallel configuration (on - HP RP36000/3 | HP 3 Phase UPS Parallel Configuration Installation Instructions - Page 4
. Be sure to verify polarity while connecting the REPO port in parallel with other HP UPSs. WARNING: To meet the requirements stated in NEC (NFPA " in the user guide. For information about verifying the REPO connection, see "Verifying the REPO port connection" in the user guide. Connecting to - HP RP36000/3 | HP 3 Phase UPS Parallel Configuration Installation Instructions - Page 5
the UPSs to the Bus Bar Connect the parallel input cord from each paralleled UPS to the Bus Bar in the rack. Gently loop and twist the parallel input cords to minimize stress on the cords "). Resolve any active alarms before continuing. For alarm troubleshooting, see "LED and audible alarm - HP RP36000/3 | HP 3 Phase UPS Parallel Configuration Installation Instructions - Page 6
charge before putting the UPS into service. IMPORTANT: Charge the batteries for at of their capacity within 48 hours Powering up the parallel system NOTE: Be sure that the total equipment HP logo appears. 7. To change any other factory-set defaults, see "UPS operations" in the user guide. NOTE: HP
-
1 -
2 -
3 -
4 -
5 -
6
 |
 |
HP 3 Phase UPS parallel
configuration
Installation Instructions
3 Phase UPS overview
The HP 3 Phase UPS features a 6U rack-mount design which offers
power protection for loads up to 12000 VA/12000 W.
For more information about any of the topics covered in this
document, see the UPS user guide located on the documentation CD
or HP website (http://www.hp.com/go/rackandpower
).
Precautions
Save these instructions. This document contains important safety
instructions that should be followed during installation, operation,
and maintenance of the UPS and batteries.
WARNING:
A risk of personal injury from electric shock
and hazardous energy levels exists. The installation of
options and routine maintenance and service of this
product must be performed by individuals who are
knowledgeable about the procedures, precautions, and
hazards associated with AC power products.
WARNING:
To prevent personal injury from earth
conductor leakage current:
•
Do not operate the UPS while disconnected from the
utility power source.
•
Disconnect load devices before disconnecting the UPS
from the utility power source.
127 kg
280 lb
This symbol indicates that the UPS exceeds the
recommended weight for one individual to handle
safely.
WARNING:
To reduce the risk of personal injury
or damage to the equipment, observe local
occupational health and safety requirements and
guidelines for manual material handling.
© Copyright 2007, 2008 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Part Number 456066-002
June 2008 (Second Edition)