HP S10614 cable management d-ring rack option kit installation instructions
HP S10614 Manual
View all HP S10614 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP S10614 manual content summary:
- HP S10614 | cable management d-ring rack option kit installation instructions - Page 1
management d-ring rack option kit installation instructions Read instructions completely before beginning installation procedure. About This Device The HP Cable Management D-Ring Rack Option Kit is designed for use with all HP Series racks to assist with cable management. Kit Contents The items - HP S10614 | cable management d-ring rack option kit installation instructions - Page 2
on the cable management d-ring (2). Front-Mount 1. Place a cable management clip on the cable management d-ring. See "Side-Mount" step 1. 2. Install a cage nut, provided in the original rack hardware kit. 1 2 2. Align the d-ring with the appropriate screw hole (1) and secure the d-ring with one
hp cable
management d-ring
rack option kit
installation instructions
Read instructions completely before beginning
installation procedure.
Hewlett-Packard Company shall not be liable for technical or editorial errors or
omissions contained herein. The information in this document is provided “as is”
without warranty of any kind and is subject to change without notice. The warranties
for HP products are set forth in the express limited warranty statements
accompanying such products. Nothing herein should be construed as constituting an
additional warranty.
hp cable management d-ring rack option kit installation instructions
First Edition (December 2002)
Part Number 313468-021
313468- 021
About This Device
The HP Cable Management D-Ring Rack Option Kit is designed
for use with all HP Series racks to assist with cable management.
Kit Contents
The items and quantities required for installation include:
•
Cable management d-ring (10)
•
Cable management clip (10)
•
5.5-mm (.22 inches) thread-forming screw (10)
This kit may contain extra pieces of hardware for your
convenience.
Tool Required
You will need a Phillips screwdriver.
Additional Hardware
You will need the following components from the original rack
hardware kit:
•
M-6 screws
•
M-6 cage nuts
•
Cage nut insertion tool
Rack Considerations
Before beginning these procedures, be sure you understand and
follow these precautions:
WARNING:
To reduce the risk of personal injury or damage to
the equipment be sure that:
•
The leveling jacks are extended to the floor.
•
The full weight of the rack rests on the leveling jacks.
•
The stabilizing feet are attached to the rack if it is a
single-rack installation.
•
The racks are coupled in multiple-rack installations.
•
Only one component is extended at a time. A rack may
become unstable if more than one component is extended
for any reason.