HP Superdome SX2000 Installation Guide, Sixth Edition - HP Integrity Superdome - Page 40

A 5-Wire Connector, WARNING, Installing the PDCA

Get HP Superdome SX2000 PDF manuals and user guides View all HP Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

Figure 1-27 A 5-Wire Connector To install the PDCA, follow these steps: WARNING! Make sure the circuit breaker on the PDCA is OFF. 1. Remove the rear PDCA bezel by removing the four retaining screws. 2. Run the power cord down through the appropriate opening in the floor tile. 3. Insert the PDCA into its slot (Figure 1-28 (page 40)). Figure 1-28 Installing the PDCA 4. Using a T-20 driver, attach the four screws that hold the PDCA in place. 5. If required, repeat step 2 through step 4 for the second PDCA. 40 Installing the System

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
Figure 1-27 A 5-Wire Connector
To install the PDCA, follow these steps:
WARNING!
Make sure the circuit breaker on the PDCA is
OFF
.
1.
Remove the rear PDCA bezel by removing the four retaining screws.
2.
Run the power cord down through the appropriate opening in the floor tile.
3.
Insert the PDCA into its slot (
Figure 1-28 (page 40)
).
Figure 1-28 Installing the PDCA
4.
Using a T-20 driver, attach the four screws that hold the PDCA in place.
5.
If required, repeat step 2 through step 4 for the second PDCA.
40
Installing the System