HP Surestore 1200ex Adding 2 Drives to the C1107 Series Jukebox - C1158-90001
HP Surestore 1200ex - Optical Jukebox Manual
 |
View all HP Surestore 1200ex manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Surestore 1200ex manual content summary:
- HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 1
the C1107 Series Jukebox Important! Read This First This upgrade requires code to be downloaded to the controller PCA and the drives. BEFORE starting this upgrade, obtain the following: * The downloadable code required for this upgrade. Obtain this code from www.hp.com/isgsupport/optical/fw/firmware - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 2
©Hewlett-Packard Company, 1998 - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 3
must first install a capacity upgrade( C1159F/G/H). Installing a capacity upgrade gives the product a C1107F/G/H configuration. ESD Precautions The optical disk jukebox contains very sensitive electrical components. It is EXTREMELY IMPORTANT that you follow the proper procedures for preventing ESD - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 4
are needed for assembly/disassembly of the autochanger: • Torx driver with the following bits: T-10, T-20 Kit Contents instructions Note This document is not necessarily revised as each part number is revised. In the above list, an "x" is placed in "service" part numbers (parts orderable from Support - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 5
so they can be replaced to their ORIGINAL positions. Failure to follow this practice results in a serious loss of file system integrity. 1. Look in the jukebox front "window" and make sure that there are no disks in any drive. Use the control panel to eject any disk still in a drive 2. Bring - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 6
the top 2 drive enclosures, and will add 2 drives to the drive enclosure that is 3rd from the top. If you are upgrading a 1/2-capacity configuration jukebox with 6 drives, you must add the capacity upgrade (C1159F/G/ H, which includes 3 empty drive enclosures) at the same time that you add the drive - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 7
Figure 1: Drive locations in 8-, 10-, and 12-drive upgrades 7 - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 8
1. Remove the 3 right-side panels. The side panels have 2 T-20 screws on the bottom edge. Start from the bottom panel first. Figure 2: Screws on side and rear panels 2. Remove the two RFI panels . There are 6 T-20 screws around the edge of each panel. Figure 3: Lower and upper RFI panels 8 - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 9
3. If upgrading to an 8- or 12-drive configuration, remove the first available (empty) drive enclosure from the top. If upgrading to a 10-drive configuration, remove the drive enclosure at position #6 (see Figure 1). a. Disconnect the fan power cable from the interposer PCA. b. Remove the 2 T-20 screws - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 10
6. Check the DIP switches on the top of the drives. Make sure they are set to OFF, which is in the forward position (toward the front of the drive.) Refer to Figure 5 for DIP switch location and orientation on the top of the drives. Figure 5: Orientation of the drive DIP switches 7. Install drives - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 11
8. Insert the drive interface, power, and SCSI cables into the drive enclosure. a. Insert the SCSI cable through the enclosure opening from the inside to the outside of the enclosure, so that the taller, folded end is inside the drive enclosure, just behind the interface cable. b. Insert the (double - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 12
d. Slide the first drive into the BOTTOM of the drive enclosure. Note If you can't get the drive all the way into the enclosure, loosen the T-10 screws that secure the bottom access panel (one screw on each side panel). This provides a little more room, and the drive will slide right in. Note As the - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 13
Figure 10: Drives mounted - enclosure top access plate on j. Re-install the top drive cable access panel on the drive enclosure by replacing and tightening the 2 T-10 screws that previously held the cover in place. (Tighten the screws holding the bottom access panel if they were loosened. Note At - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 14
bottom edges of the drive enclosure pass over the two tabs protruding from the sides of the drive stack. Figure 12: Slots and tabs that support the drive enclosure 14 - HP Surestore 1200ex | Adding 2 Drives to the C1107 Series Jukebox - C1158-90001 - Page 15
cable 3 - fan power cable 4 - power cable (over the SCSI cable) Use the drive cables mounted on the upper interposer PCA as a guide. Note If you are upgrading this jukebox to a TOTAL of 8 drives or 10 drives, you must plug a capacitive load (terminator) to one of the SCSI cable connectors on the
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
 |
 |
Adding 2 Drives to the
C1107 Series Jukebox
HP Part No.
C1158-90001
Printed in USA February, 1998
Edition 2
0298
*
A utility to download the code - SCSI Pro from CoComp
or SCSI Toolbox from
*
A PC with a SCSI interface and appropriate cables
Important! Read This First
BEFORE
starting this upgrade, obtain the following:
*
The downloadable code required for this upgrade. Obtain this code
from www.hp.com/isgsupport/optical/fw/firmware.html
This upgrade requires code to be downloaded to the controller PCA and the drives.
Peripheral Test Instruments (PTI).