HP Xw4600 HP Workstations - Installing a Hood Lock (Smart Cover Lock) and Hood
HP Xw4600 - Workstation - 2 GB RAM Manual
UPC - 883585516483
View all HP Xw4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Xw4600 manual content summary:
- HP Xw4600 | HP Workstations - Installing a Hood Lock (Smart Cover Lock) and Hood - Page 1
instructions on installing and removing components on your HP Workstation, refer to the Service and Technical Reference Guide for your unit. For HP Workstation support information, visit www.hp.com/go/bizsupport. Removing the Top Panel To remove the top panel: 1. Disconnect power from the system - HP Xw4600 | HP Workstations - Installing a Hood Lock (Smart Cover Lock) and Hood - Page 2
xw8200, does not connect to the system board. Instead, the hood sensor cable connects to the front control panel cable. The front control panel cable is located beneath the hard drive cage. 367829-001 2 © 2004 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark - HP Xw4600 | HP Workstations - Installing a Hood Lock (Smart Cover Lock) and Hood - Page 3
HP xw6200 HP Smart Cover Lock and Hood Sensor Installation Guide HP Service and Technical Reference Guide HP Web www.hp.com/go/bizsupport 1 2 1 1 3 4 3 1 - HP Xw4600 | HP Workstations - Installing a Hood Lock (Smart Cover Lock) and Hood - Page 4
xw6200 、 xw8200 367829-001 2 © 2004 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P.
1
Installing a Hood Lock (Smart Cover Lock)
and Hood Sensor on HP Workstations
The installation location for the hood lock on some HP workstations, such as the xw6200, is located under
the top panel of the unit. If this is the case with your workstation, use this document and the
Smart Cover
Lock and Hood Sensor Installation Guide
, included in this kit, to install the hood lock and hood sensor.
NOTE:
For detailed instructions on installing and removing components on your HP Workstation, refer to
the
Service and Technical Reference Guide
for your unit. For HP Workstation support information, visit
www.hp.com/go/bizsupport
.
Removing the Top Panel
To remove the top panel:
1.
Disconnect power from the system, remove the hood cover, and remove the front bezel.
2.
Insert a flat-blade screw driver into the slot
1
as shown.
3.
Gently pull down on the screw driver to disengage the cover from the unit.
4.
Slide the cover back about an inch and then lift it off the unit.
1