HP Xw4600 HP xw Workstation series - Rack mount tray installation
HP Xw4600 - Workstation - 2 GB RAM Manual
 |
UPC - 883585516483
View all HP Xw4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Xw4600 manual content summary:
- HP Xw4600 | HP xw Workstation series - Rack mount tray installation - Page 1
Rack guide strips ● M5 and M6 hardware packets ● Rack mount template card ● Warranty ● Rack mount installation instructions ● Rack mount tray Required tools These tools are helpful for installing the rack mount tray: ● T-15 and T-20 Torx drivers ● Cross-tip driver © 2007 Hewlett-Packard Development - HP Xw4600 | HP xw Workstation series - Rack mount tray installation - Page 2
power cord from the electrical outlet. WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper workstation, setup, posture, and health and work habits for computer the system parts removal/replacement procedures: HP accessories are for use in HP workstation - HP Xw4600 | HP xw Workstation series - Rack mount tray installation - Page 3
the workstation. 2. Disconnect power from the workstation. For product-specific information, see the Service and Technical Reference Guide for your HP workstation at http://www.hp.com/support/workstation_manuals. Step 2-Attaching the rack mount tray to the workstation 1. Using a T-15 Torx driver - HP Xw4600 | HP xw Workstation series - Rack mount tray installation - Page 4
a T-15 Torx driver to fasten the tray to the workstation with the two chassis screws set aside in Step 1. Step 3-Mounting the workstation rack 1. Attach the rails to the rack. Refer to the rail installation instructions in this kit. 2. Remove the adhesive backing from the back of the guide strips
-
1 -
2 -
3 -
4
 |
 |
Rack mount tray installation
HP xw4000 Workstation series
This document describes how to install a rack mount tray on an HP xw4000 series workstation. It also
describes how to mount the workstation in a rack.
Kit contents
This kit includes the following components:
●
Rail Assembly
●
Rack guide strips
●
M5 and M6 hardware packets
●
Rack mount template card
●
Warranty
●
Rack mount installation instructions
●
Rack mount tray
Required tools
These tools are helpful for installing the rack mount tray:
●
T-15 and T-20 Torx drivers
●
Cross-tip driver
© 2007 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered
trademark of Hewlett-Packard Development Company, L.P. Printed in the U.S.
ENWW
HP xw4000 Workstation series
1