HP Xw4600 HP xw4000 Series and Z400 Workstations - Rack mount tray installatio
HP Xw4600 - Workstation - 2 GB RAM Manual
UPC - 883585516483
View all HP Xw4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Xw4600 manual content summary:
- HP Xw4600 | HP xw4000 Series and Z400 Workstations - Rack mount tray installatio - Page 1
the HP 400 and xw4000 Workstation series into a rack mount tray. It also describes how to mount the workstation-tray assembly into a rack. Kit contents ● Rail assembly ● Rack glide strips ● M5 and M6 hardware packets ● Rack mount template card ● Warranty ● Rack mount installation instructions ● Rack - HP Xw4600 | HP xw4000 Series and Z400 Workstations - Rack mount tray installatio - Page 2
Comfort Guide. It describes proper workstation setup, posture, health, and work habits for computer users, and provides important electrical and mechanical safety information. This guide is located at http://www.hp.com/ergo and on the documentation CD (if one is included with the product). CAUTION - HP Xw4600 | HP xw4000 Series and Z400 Workstations - Rack mount tray installatio - Page 3
NOTE: All illustrations are examples only. Workstation models vary. For product-specific information, see the service guide for your HP workstation at http://www.hp.com/support/workstation_manuals before beginning installation. To prepare the workstation for component installation: 1. Power down the - HP Xw4600 | HP xw4000 Series and Z400 Workstations - Rack mount tray installatio - Page 4
4. Use a T-15 Torx screwdriver to fasten the tray to the workstation with the two chassis screws saved earlier. Step 3-Mounting the workstation rack 1. Attach the rails to the rack. See the rail installation instructions in this kit. 2. Remove the adhesive backing from the back of the glide - HP Xw4600 | HP xw4000 Series and Z400 Workstations - Rack mount tray installatio - Page 5
document is available in Japanese. See http://www.hp.com/support/workstation_manuals, then select your workstation product and select Japanese from the drop down Manual Language menu http://www.hp.com/support/workstation_manuals Manual Language Japanese ENWW Step 4-Completing installation 5
Rack mount tray installation
Introduction
This document describes how to install the HP
400 and xw4000 Workstation series into a rack mount
tray. It also describes how to mount the workstation-tray assembly into a rack.
Kit contents
●
Rail assembly
●
Rack glide strips
●
M5 and M6 hardware packets
●
Rack mount template card
●
Warranty
●
Rack mount installation instructions
●
Rack mount tray
Required tools
●
T-15 Torx screwdriver
●
T-20 Torx screwdriver
●
Cross-tip screwdriver
© 2005–2009 Hewlett-Packard Development Company, L.P. Printed in the U.S.
ENWW
Introduction
1