HP Xw8200 SATA device configuration guidelines

SATA device configuration guidelines

HP xw8x00 and xw9x00 Workstations

This document describes how to configure SATA devices in HP xw8x00 and xw9x00 Workstations.

NOTE:

SATA ports on the workstation are not hot swappable.

1.

Begin connecting the SATA mass storage device cables to the workstation SATA ports, typically

starting with SATA port 0. The port 0 connector is identified by a unique color.

NOTE:

Refer to the service label on the inside of the workstation access panel for SATA and SAS

port details.

Figure 1

SATA ports

Example: HP xw8400 Workstation SATA ports

Example: HP xw9400 Workstation SATA ports

2.

Continue connecting the mass storage devices to unused SATA ports.

TIP:

Connect the hard drives first. When all hard drives are connected, begin connecting the

optical devices.

NOTE:

All internal bay SATA hard drives are supported only on the system board SATA ports.

An external SATA hard drive is supported on either an eSATA or a SAS controller card port.

August 2009, 459722-002

HP xw8x00 and xw9x00 Workstations