HP Xw8200 Creative Sound Blaster X-Fi - Quick Start Guide
HP Xw8200 - Workstation - 1 GB RAM Manual
 |
UPC - 882780210455
View all HP Xw8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Xw8200 manual content summary:
- HP Xw8200 | Creative Sound Blaster X-Fi - Quick Start Guide - Page 1
, see the system requirements section) ■ Cable clip ■ Regulatory compliance notices ■ Warranty information System Requirements ■ HP Workstation xw series (except xw3100) ■ Microsoft Windows XP Service Pack 1 (SP1) or newer operating system ■ Optical drive ■ Empty PCI slot Warranty Information Any - HP Xw8200 | Creative Sound Blaster X-Fi - Quick Start Guide - Page 2
Close the chassis side cover. 11. Connect the AC power, turn on the computer, and wait for the hp.com to see if there are newer drivers available for your product. 13. After you have installed the software, refer to the "Online manual" or your speaker manufacturer documentation for instructions - HP Xw8200 | Creative Sound Blaster X-Fi - Quick Start Guide - Page 3
Shipping your HP Workstation If shipping your HP xw6, HP xw8 or HP xw9 series Workstation, it is recommended to install the shipping support arm. For standard desktop use, the shipping support is not required. Adding Support Arm to Card Support Assembly (xw8 and xw9 Series Only) 1. Add a new arm and - HP Xw8200 | Creative Sound Blaster X-Fi - Quick Start Guide - Page 4
the HP xw6 Series Support Arm To install the support are for xw6 series workstations: 1. Insert the arm by engaging the hooks in the openings along the edge of the rear of the chassis. 2. Lower the arm over the card. 410708-001 © 2005 Hewlett-Packard Development Company, L.P. The HP Invent
-
1 -
2 -
3 -
4
 |
 |
Creative Sound Blaster X-Fi
Quick Start Guide
This document describes the hardware and software installation of the Creative Sound Blaster X-Fi. For
more information, refer to the
Installation and Application
CD.
Package Contents
System Requirements
■
HP Workstation xw series (except xw3100)
■
Microsoft Windows XP Service Pack 1 (SP1) or newer operating system
■
Optical drive
■
Empty PCI slot
Warranty Information
Any warranty information is superseded by the HP warranty term provided in the warranty document.
Installing the Card and Software
To install the X-Fi card:
1.
Turn off your computer and unplug the AC power cable.
2.
Open the chassis and remove the rear PCI metal slot cover where you plan to install the sound card.
3.
Disconnect the front audio cable from the front audio header on the system board.
If your system came with a CD audio cable that connects the optical drive to the system board,
disconnect the cable from the system board end only and leave the optical drive end conneted.
■
Sound Blaster X-Fi audio card
■
Front audio adapter cable (for HP Workstation
xw6 or xw8 series systems, see the system
requirements section)
■
Cable clip
■
Support arm
■
Installation and Application
CD
■
Regulatory compliance notices
■
Warranty information