Hitachi 55HDS52 Owners Guide - Page 12

First time use Rear Panel Connections ቫ Subwoofer Out Connect this SUB WOOFER OUT output to the external audio component input using the sub woofer cable provided. If the CableCARD is properly installed or removed, the TV will display the following respective screens. ቭ Upgrade Card This card slot is for future software upgrades. HITACHI will notify you if a software upgrade is required for your TV. In order to receive written notification, please complete and return your warranty card. CableCARD is installed ቮ To Power Swivel Connector Connects to the Power Swivel Table Top Stand. OR ቯ CableCARD Slot This slot is for the CableCARD that will be provided by your local cable operator to gain access to chosen cable channels. Please call your local cable operator if this service is available before requesting a CableCARD (also known as Point of Deployment (POD) module). 1. Connect a coaxial cable to cable terminal of the Rear Panel Jacks. 2. Insert the CableCARD into the slot (Top of card should be facing towards you as shown below). CableCARD is not installed After the CableCARD is installed, wait until the second screen below appears. The third screen below will appear if a channel is not authorized for viewing. Press the EXIT button to exit the second screen. Digital Cable Acquiring Data. Please wait. INSERT OR In order to start cable service for this device, please contact your cable provider CableCARD(tm): 123-456-789-1 Host: 123-456-789-1 Data: 123-456-789-1 Unit Address: 123-456-789-1 Press EXIT to return NOTE: 1. A digital cable subscription is required. 2. Do not insert a PCMCIA card into the CableCARD slot. Not an Authorized Channel Please take note of all information on the screen (you will provide this information to your cable operator). Call your cable operator and give them the information from the card to start your cable service. 12 NOTE: Please see Appendix E on page 80 for additional CableCARD information.