Hitachi DZ GX5020A Owners Guide - Page 135

Troubleshooting - finalize cord

Page 135 highlights

English *3 • This message may also appear when dirt adheres to disc. Remove the disc and then use the provided disc cleaning cloth to clean off the dirt before using it. • This message may also appear when condensation occurs. Wait until the DVD video camera/ recorder dries out, and then turn it on again. *4 • This message will appear when a single-sided disc is inserted in reverse. Reinsert the disc correctly. (Insert the disc with the label printed surface facing the outside.) *5 • Do not insert a DVD-RW (VF-mode)/DVD-R disc that has not been finalized into any DVD recorder: The disc may be unusable (except for devices that allow playback of a DVD-R disc not finalized on this DVD video camera/recorder). Troubleshooting Check to see the following before asking for a repair. If the suggested solution still cannot restore the DVD video camera/recorder to normal, do not attempt to repair it yourself, but consult your dealer. Power supplies Symptom Cause and Correction Reference page Battery cannot be charged. Is the ambient temperature too low or too high? Charge the battery at 50 - 86ºF (10 - 30ºC). Is the battery abnormally hot? Remove the battery, leave it for a while to cool down, then charge it. Is the DC power cord connected to AC adapter/charger? Unplug it. Has the battery been unused for a long time? Remove the battery, and then reattach it. If the battery is still not charged, it may be dead: Purchase a new one. • If the battery does not charge after you try the above four procedures, it may be dead: Purchase a new battery. Battery weakens fast. Are you using the DVD video camera/recorder where the temperature is low? A fully charged battery (DZ-BP07PW/DZ-BP14SW/DZ-BP7SW) may be discharged sooner than usual at low temperatures. Keep extra batteries on hand. Battery may be dead. The performance of battery will deteriorate if it is used for an extended period of time or frequently: Purchase a new battery. The CHARGE indicator on AC adapter/charger is blinking. Is the ambient temperature too low or too high? Charge the battery in environment where the temperature is 50 - 86ºF (10 - 30ºC). The battery has possibly discharged excessively. Continue charging: After a while, the battery will be charged to the specified voltage, and the CHARGE indicator will light. Then the battery charge will be completed normally. 25 27 28 25, 26 135

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158

English
135
*3
This message may also appear when dirt adheres to disc. Remove the disc and then use the
provided disc cleaning cloth to clean off the dirt before using it.
This message may also appear when condensation occurs. Wait until the DVD video camera/
recorder dries out, and then turn it on again.
*4
This message will appear when a single-sided disc is inserted in reverse. Reinsert the disc correctly.
(Insert the disc with the label printed surface facing the outside.)
*5
Do not insert a DVD-RW (VF-mode)/DVD-R disc that has not been finalized into any DVD
recorder: The disc may be unusable (except for devices that allow playback of a DVD-R disc not
finalized on this DVD video camera/recorder).
Troubleshooting
Check to see the following before asking for a repair. If the suggested solution still cannot restore the
DVD video camera/recorder to normal, do not attempt to repair it yourself, but consult your dealer.
Power supplies
Symptom
Cause and Correction
Reference
page
Battery cannot be
charged.
Is the ambient temperature too low or too high?
Charge the battery at 50 – 86ºF (10 – 30ºC).
25
Is the battery abnormally hot?
Remove the battery, leave it for a while to cool down, then charge
it.
Is the DC power cord connected to AC adapter/charger? Unplug
it.
Has the battery been unused for a long time?
Remove the battery, and then reattach it. If the battery is still not
charged, it may be dead: Purchase a new one.
If the battery does not charge after you try the above four
procedures, it may be dead: Purchase a new battery.
Battery weakens fast.
Are you using the DVD video camera/recorder where the
temperature is low?
A fully charged battery (DZ-BP07PW/DZ-BP14SW/DZ-BP7SW)
may be discharged sooner than usual at low temperatures. Keep
extra batteries on hand.
27
Battery may be dead.
The performance of battery will deteriorate if it is used for an
extended period of time or frequently: Purchase a new battery.
28
The CHARGE indicator
on AC adapter/charger
is blinking.
Is the ambient temperature too low or too high?
Charge the battery in environment where the temperature is 50 –
86ºF (10 – 30ºC).
The battery has possibly discharged excessively. Continue
charging: After a while, the battery will be charged to the
specified voltage, and the CHARGE indicator will light. Then the
battery charge will be completed normally.
25, 26