Honeywell 5802mn Setup Guide

N7131V5

5/04

Rev. A

ADEMCO 5802MN

SUPERVISED MINIATURE

TRANSMITTER

INSTALLATION AND SETUP GUIDE

The ADEMCO 5802MN is a wireless transmitter that may

be worn on a belt (belt holder supplied) or around the

neck (necklace supplied). Pressing the button on the

transmitter sends a signal to the control receiver. The

5802MN is intended for use only with wireless alarm

systems that support 5800 Series devices.

The

transmitter

is

supervised,

i.e.,

every

hour

it

automatically sends a message to the control receiver

that includes battery status information.

This transmitter can be programmed as any zone type

response (e.g., Emergency Panics, Relay Action, etc.).

Battery Replacement

The 5802MN is powered by a long-life Lithium battery that

may be replaced when a low battery is eventually

indicated by the control unit.

NOTE:

Although the 5802MN is water-resistant, please

do not submerge.

Programming the Serial Number

The 5802MN has a unique identification code (serial

number) permanently assigned during manufacture.

You must “enroll” the transmitter’s serial number and loop

number during system programming. The 5802MN may

be defined as Input Type “RF” (supervised RF, for an

hourly check-in;

do not

take out of range) or “UR”

(Unsupervised RF). Its loop number is “1.” See the control

unit’s Installation Instructions for further details regarding

programming.

When installation is complete, verify operation from

desired location(s).

Specifications

Unit Dimensions:

2.4” (61mm) x 1.5” (38mm) x 0.5” (13mm)

LED:

Lights when unit transmits.

Battery:

3V Duracell DL 2032 or Newsum, Maxell, Panasonic,

Renata, or Sanyo CR2032

In UL installations: 3V Newsum, Maxell, or

Renata CR2032 only

▲

▲

▲

▲

▲

▲

▲

▲

▲

▲

Back of 5802MN

Remove

battery

cover

Slide

battery

under

pin

Battery

3V

LITHIUM

RENATA

CR2032

5820MN

Battery access is via a

quarter

turn

(use a nickel to open

case back). Excessive turning

may result in damaging the

cover.

Note battery polarity:

+ POS

end must face up

(visible when installed).

REFER

TO

THE

INSTALLATION

INSTRUCTIONS

FOR

THE

RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED FOR

WARRANTY INFORMATION AND FOR DETAILS REGARDING THE

LIMITATIONS OF THE ENTIRE ALARM SYSTEM.

FCC STATEMENT

FCC ID: CFS8DL5802MN

CANADA: 1748101382 5 3

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference

(2) This device must accept any interference received, including

interference that may cause undesired operation.

UL

US Listings:

HOUSEHOLD BURGLARY WARNING SYSTEM

CONTROL

UNIT

ACCESSORY

UL

Canadian

Listings:

HOUSEHOLD BURGLARY WARNING SYSTEM CONTROL UNIT

ACCESSORY ALSO LISTED FOR USE AS A SIGNAL APPLIANCE,

MISCELLANEOUS CERTIFIED FOR CANADA.

ÊN7131V5WŠ

N7131V5

5/04

Rev. A

Honeywell 5802mn Setup Guide

Honeywell 5802mn - Ademco Wireless Emergency Transmitter Manual

Honeywell 5802mn manual content summary: