Honeywell 6160V User Guide
Honeywell 6160V - Ademco Talking Alpha Display Keypad Manual
 |
UPC - 781410414808
View all Honeywell 6160V manuals
Add to My Manuals
Save this manual to your list of manuals |
Honeywell 6160V manual content summary:
- Honeywell 6160V | User Guide - Page 1
. B ADEMCO 6150V & 6160V Voice Remote Keypad USER GUIDE This document provides Operating Instructions for your Keypad's voice features. Refer to your security system User Guide for all other security system functions and operating procedures. Message Center The ADEMCO 6150V/6160V Keypads feature - Honeywell 6160V | User Guide - Page 2
any system and/or zone faults (if they exist) by first turning on the Voice Chime mode (see above). When Voice Chime mode is on, pressing the STATUS key displays and announces current system status and zone descriptors (programmed by your installer) of faulted zones. If zone descriptors are not
-
1 -
2
 |
 |
K0022UGV1
12/01
Rev. B
ADEMCO 6150V & 6160V
Voice Remote Keypad
USER GUIDE
This document provides Operating Instructions for your Keypad’s voice features.
Refer to your
security system User Guide for all other security system functions and operating procedures.
Message Center
The ADEMCO 6150V/6160V Keypads feature a
voice message center that lets you record and
playback one message.
•
The message can be up to 2.5-minutes long
•
The message remains in the Keypad’s memory
until a new message is recorded.
•
The volume control of the message is adjustable.
•
Refer to the procedures below when using the
Message Center functions.
1
OFF
4
MAX
7
INSTANT
READY
2
AWAY
5
TEST
8
CODE
0
3
STAY
6
BYPASS
9
CHIME
#
ARMED
READY
6160V-00-005-V0
MESSAGE
MIC
RECORD
VOLUME
PLAY
STATUS
VOICE
FUNCTION
VOLUME
KEY
VOICE
KEY
STATUS
KEY
FUNCTION
KEY
DOWN
VOLUME
PLAY KEY
AND
UP VOLUME
RECORD
KEY
SPEAKER
LCD
DISPLAY
MICROPHONE
LEDs
To record a message:
Press [#] FUNCTION + [0] VOICE + [1] RECORD keys.
The red MESSAGE indicator will light, indicating record in progress.
Note
:
A message cannot be recorded during the Exit Delay period.
To end recording:
Press [1] RECORD key.
The red MESSAGE LED will flash indicating a message waiting to be
played.
After the message is played once the MESSAGE LED will go
out.
To play a message:
Press [#] FUNCTION + [0] VOICE + [3] PLAY keys.
The recorded message plays and the red MESSAGE LED turns off.
The
recorded message will remain in memory until a new message is
recorded.
To adjust the volume:
Press [#] FUNCTION + [0] VOICE + [2] VOLUME keys,
then press the desired volume control key [3]
↑
(up) or [6]
↓
(down).
Note:
•
Adjusting message volume also adjusts status volume.
Volume
cannot be adjusted while playing a message.
•
Each time you enter the command to adjust the volume, the word
“CHECK” will be heard to verify the current setting.
(Continued on Other Side)