Honeywell CT3200 Owner's Manual - Page 21
Frequently asked questions - reset
View all Honeywell CT3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Frequently asked questions If... Display will not come on Temperature display will not go lower than 45°F (7°C) or higher than 88°F (31°C) during programming Display shows flashing or steady "bAt Lo" Temperature change occurs at the wrong times Heating will not come on Then... • Make sure the batteries are fresh and installed correctly. • Set the System switch to OFF. Remove the batteries and then insert them backwards for five to ten seconds to reset the thermostat. Replace the batteries correctly. The display should come on. • You have reached the temperature limit. The setting range is 45°F-88°F (7°C-31°C). • The batteries are low; replace them as soon as possible. See page 18 for instructions. • If "bAt Lo" continues to display after replacing the batteries, set the System switch to OFF and insert the batteries backwards for five to ten seconds. Then replace the batteries correctly. The display should come on. • Check the program times for the period in question. Be sure that the AM and PM indications are correct. Make sure the current day and time are correct. Reprogram if necessary. • Check that the System switch is set to HEAT. • Check the system fuse or circuit breaker and replace or reset if necessary. • Check for correct wiring and good connections. • If display is blank or displays "bAt Lo," install fresh batteries. • Allow time for the furnace to heat up and the fan to come on before checking for heat at the register. • If the temperature setting is higher than the current room temperature and the SYSTEM ON arrow is displayed, the thermostat is operating correctly. Contact a heating contractor for assistance. 69-0653-6 FREQUENTLY ASKED QUESTIONS 21