Honeywell HZ-338 User Guide

IMPORTANT

SAFEGUARDS

READ AND SAVE THESE

SAFETY INSTRUCTIONS

BEFORE USING THIS

HEATER.

When using electrical appliances, basic precautions

should always be followed to reduce the risk of fire,

electric shock, and injury to persons, including the

following:

IMPORTANT

INSTRUCTIONS

1. Read all instructions before using this heater.

2. This heater is hot when in use. To avoid burns, do not

let bare skin touch hot surface. If provided, use han-

dles when moving this heater. Keep combustible

materials, such as furniture, pillows, bedding,

papers, clothes, and curtains at least 3 feet (0.9 m)

from the front of the heater and keep them away from

the sides and rear.

3. Extreme caution is necessary when any heater is

used by or near children or invalids and whenever

the heater is left operating and unattended.

4. Always unplug heater when not in use.

5. Do not operate any heater with a damaged cord or

plug or after the heater malfunctions, has been

dropped or damaged in any manner. Return heater

to authorized service facility for examination, electri-

cal or mechanical adjustment, or repair.

6. Do not use outdoors.

7. This heater is not intended for use in bathroom, laun-

dry areas and similar moist indoor locations. Never

locate heater where it may fall into a bathtub or other

water container.

8. Do not run cord under carpeting. Do not cover cord

with throw rugs, runners, or the like. Arrange cord

away from traffic areas where it will not be tripped

over.

9. This appliance has a polarized plug (one blade is

wider than the other). To reduce the risk of shock,

this plug is intended to fit only one way in a polarized

outlet. If the plug does not fit fully in the outlet,

reverse the plug. If it still does not fit, contact a quali-

fied electrician.

DO NOT

attempt to defeat this

safety feature.

10. This heater draws 12.5 amps during operation. To

prevent overloading a circuit, do not plug the heater

into a circuit that already has other appliances work-

ing.

11. It is normal for the plug to feel warm to the touch;

however, a loose fit between the AC outlet (recepta-

cle) and plug may cause overheating and distortion

of the plug. Contact a qualified electrician to replace

loose or worn outlet.

12. To disconnect the heater, first turn controls to the

OFF

position, then grip the plug and pull it from the

wall outlet. Never pull by the cord.

13. Do not insert or allow foreign objects to enter any

ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.

14. To prevent a possible fire, do not block air intakes or

exhaust in any manner. Do not use on soft surfaces,

like a bed, where openings may become blocked.

15. A heater has hot and arcing or sparking parts inside.

Do not use it in the areas where gasoline, paint, or

flammable liquids are used or stored.

16. Use this heater only as described in this manual.

Any other use not recommended by the manufac-

turer may cause fire, electric shock, or injury to per-

sons.

17. Avoid the use of an extension cord because the

extension cord may overheat and cause a risk of fire.

However, if you have to use an extension cord, the

cord shall be No. 14 AWG minimum size and rated

not less than 1875 watts.

18. The output of this heater may vary and its tempera-

ture may become intense enough to burn exposed

skin. Use of this heater is not recommended for per-

sons with reduced sensitivity to heat or an inability to

react to avoid burns.

19.

SAVE THESE

INSTRUCTIONS.

1

70

°

DIGITAL CERAMIC

HEATER

HZ-335, HZ-336 Series

Honeywell HZ-338 User Guide

Honeywell HZ-338 - Sure Set 1500W Ceramic Heater Manual

Honeywell HZ-338 manual content summary: