Honeywell MS9535-5 User Manual - Page 18
Full Speed USB (Powered by the Host Device), Establish communication, between the scanner and, cradle.
View all Honeywell MS9535-5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
CRADLE INSTALLATION TO THE HOST DEVICE Full Speed USB (Powered by the Host Device) 1. Turn off the host device. 2. Connect the 10-pin RJ45 male connector into the 10-pin modular jack on the bottom of the charger cradle. 3. Connect the female DC power jack of the USB cable to the center power jack on the bottom of the charger cradle. 4. Connect the USB Type A plus power connector to the USB port on the host device. 5. Turn on the host device. 6. Establish communication between the scanner and cradle. See page 15 for complete instructions on Establishing Bluetooth Communication between the scanner and cradle. Figure 10. Full Speed USB The scanner must be charged for a minimum of 3 hours before the scanner can be placed in full operation for the first time. After the initial preparation charge of 3 hrs, the battery will only require 2.5 hrs to come to a full charge when it gives a Low Power warning (see page 18). See page 6. 14