Honeywell MS9535-5 User Manual - Page 22
THE MI9535-5XX Receiver / Charger Cradle, Charging Guidelines and Low Battery Indicators - reset
View all Honeywell MS9535-5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
THE MI9535-5XX RECEIVER / CHARGER CRADLE Charging Guidelines and Low Battery Indicators The scanner should be fully charged prior to being placed into service. Metrologic recommends that Bluetooth communication between the scanner and the cradle be established first before charging. To charge the scanner, place the unit into the cradle. The amber LED on the scanner will begin to flash indicating the charging process has begun. For first time installations, leave the scanner in the cradle for a full 3 hours. Please note that the amber LED on the scanner will stop flashing after 2.5 hours but it is recommended that the scanner be left in the cradle for an additional 30 minutes to complete the initial 3 hour charge. Once the initial 3 hour charge is complete, the battery will only require 2.5 hours to come to a full charge when the unit gives a low power warning. A steady amber LED on the scanner will indicate the completion of a full charge. Low Battery Warning The following items indicate the scanner battery is low and will need to be recharged. z During operation, the scanner gives two beeps after a successful scan. z The laser is not activated when a bar code is presented in the scanner's IR range and the scanner has automatically entered normal sleep mode to reserve power. z The CodeGate button is pressed, the laser comes on briefly but does not stay on and the scanner has automatically entered normal sleep mode to reserve power. z The CodeGate button is pressed but the laser does not turn on. Manufacturer's Recommendation If the scanner is not be used for a long period of time, it is recommended that the unit be placed into normal or full sleep mode to save power. z To enable normal sleep mode, scan the configuration bar codes in the MetroSelect Single-Line Configuration Guide (MLPN 00-02544x). z To enable full sleep mode, after the laser shuts off, depress the CodeGate button and hold for 3 seconds, the scanner will give a long beep and switch into full sleep mode. To wake-up the scanner from either mode, depress the CodeGate button. After an automatic reset, the scanner is ready for normal operation. 18