Honeywell WAP Quick Installation Guide

Honeywell WAP Manual

Get Honeywell WAP PDF manuals and user guides View all Honeywell WAP manuals
Add to My Manuals
Save this manual to your list of manuals

Honeywell WAP manual content summary:

  • Honeywell WAP | Quick Installation Guide - Page 1
    WAP Wireless Access Point - Quick Installation Guide For Online Support visit: http://www.security.honeywell.com/hsc/resources/MyWebTech/ General Information This guide provides information on installing and setting up Honeywell's WAP Wireless Access Point. The WAP provides an easy-to-setup secure
  • Honeywell WAP | Quick Installation Guide - Page 2
    for wireless security. • If using a router instead of Honeywell's WAP, please ensure your router is configured for DHCP. (This is the default setting for most routers.) If you are unsure, you can access the router's configuration page and set it for DHCP if necessary (refer to the router's manual
  • 1
  • 2
WAP Wireless Access Point – Quick Installation Guide
General Information
This guide provides information on installing and setting up Honeywell's WAP Wireless Access
Point.
The WAP provides an easy-to-setup secure wireless solution that enables Honeywell's
iPCAM series internet video cameras to communicate with a broadband modem or LAN.
Some major features of Honeywell's WAP Wireless Access Point are:
•
Functions as a secure wireless access point.
•
Wireless communications utilizes the 802.11b/g/n protocol with WPS security.
WPS (Wi-Fi
Protected Setup) is a standard for easy setup of a secure wireless network.
•
In addition to wireless communications, there are three 10/100 Mbps Ethernet ports
available for wired cameras.
IMPORTANT: This device is for indoor use only.
PACKAGE CONTENTS
LAN
Wireless
WPS
Reset
Security
Power
WAP Wireless Access Point
Antenna [Qty 2]
Power Transformer
Ethernet Cable
Component Identification
Security
WPS
Wireless
LAN
Power
Reset
Security:
On – WPS security is set to on.
Flashing – Flashes when WPS button has
been pressed for 3 seconds and released,
to indicate the WAP is transmitting a new
security key to the wireless camera.
When
the wireless camera replies, the Security
LED lights solid.
WPS (button):
Used to setup a secured
wireless connection.
(Refer to the
documentation for the wireless camera.)
Wireless:
On – Wireless connection exist.
Off – No Wireless connections exist.
Flashing (Amber) – Problem occurred while
trying to establish the Wireless connection.
LAN:
On – The LAN port(s) is active.
Flashing (Amber) – Problem occurred while
trying to connect to the LAN.
Power:
When power is applied the LED
blinks during an initialization period, then
remains steady to indicate power is
connected.
Reset (switch):
This switch has two
functions; Reboot
, and Clear All Data
.
Use
a paper clip to depress.
Reboot
– Depress and Release to reboot.
(Allow cycle to complete.)
Clear All Data
– Depress and hold for 8
seconds to clear all data, and restore
factory settings.
(Allow cycle to complete.)
12V / 1A:
Connect Power Transformer.
WAN:
Not Used. (Do not remove the cap plug.)
Ports 1, 2, 3, 4:
For connection to Ethernet devices.
Antenna Ports:
Connect the supplied antennas to these ports.
Antenna
Port (2)