Honeywell XL4600SM Owners Manual - Page 12

MISCELLANEOUS COMMANDS KEYPAD, SEND HELP CONDITIONS Your system can be programmed for 3 separate "Send Help" alerts which would send an emergency signal to your central station. See the System Reference sheet to see which have been programmed for your system. DURESS Your system can be programmed to send anemergency signal to the Central Station if you are forced to enter the premises. If you choose to include this feature, User Code number 15 is dedicated to this function and must only be used under a dureaa circumstance. QUICK ON - (QUICK ARMING) If programmed by your installer, Quick On, or Quick Arming, allows you to turn the system onto the away mode without user code. NOTE: Turning your system Off always requires a vatid User Code. Press [#] then [1] QUICK FORCED ON If programmed by your installer, Quick Forced On allows you to turn the bu'rglar portion of your alarm system on to the away mode, bypassing all zones that are not ready. Press [#] then [2] NOTE: A va~d user code ia still required to turn the system off. NOTE TMs feature is disabled on UL installations. QUICK BYPASS If you hava quick bypass programmed for your system, you will not have to use your user code to bypass zones. The quick bypass procedure is ZONE (l-7) NOTE: Bypassed zones are not protected when the system is turned on. After the bypass command has been accepted, the keypad sounds one long beep, and tha zone tight of the zone(s) bypaaaed will slowly bhnk, or the display will show: = "- NOTE: Temporary users fi.e. baby sitters, housekeepers, etc.) should not be shown the Bypass procedure. Page 12