Honeywell XL4600SM Owners Manual - Page 9

T(VRNING THE SYSTEM ON TURN THE SYSTEM ON WITH ALL SENSORS IN INSTANT RESPONSE MODE In INSTANT mode, all alarm sensors will repoti an alarm immediately if activated, including the doors that normally have adelayto allow youto turn the system oti. Chackto make eurethe system is ready when ready press ED Followed byyour usercode mmmrl If successful, the On/Off light and the Inetant light will be on, or the display shows. BYPASS Bypass excludes a zone of protection from the security system until it is unbypsssed (either by using the unbypaes procedure or when you turn the eystem off). Bypassing can only be done while the system is turned off. Press the Bypass Button followed by your user code and then the zone number (l-7) to be bypassed. m Followed byyour usercode+ rlmmr{ + ZONE# + If the "Quick Bypass" feature has been enabled by the installer, the user code is not required when bypassing zones. NOTE: Bypassed zones are not protected when the system is turned on. After the bypass command has been accepted, the keypad will sound one long beep, and the zonetight of the zone(s) bypassed will slowly blink, or the display shows: UNBYPASS IMPORTANT: Temporary users ~.e, baby sifters, housekeepers, etc.) should not be shown the Bypass procedure. Unbypass returns a bypassed zone to normal operation. To unbypass a zone(s), repeat the bypass function. m Followed byyourusercode rlnrlrl+ ZONES After unbypassing the zone display will show the state of the zones. Pages