Hoover C1810020 Manual

Hoover C1810020 Manual

Hoover C1810020 manual content summary:

  • Hoover C1810020 | Manual - Page 1
    Owner's Manual Operating and Servicing Instructions www.hoover.com Please review this manual before operating your Hoover® appliance. This cleaner meets Occupational Safety and Health Act (OSHA-29 CFR 1910 Subpart S) requirements. ©2008 All rights reserved. #59156659 R0. 10/08 Manuel du
  • Hoover C1810020 | Manual - Page 2
    location) to carpet 13. Adjustment Control For Carpet Pile Height: Code Conseil : Il est recommandé de joindre votre reçu de caisse au guide ring over hook to support the 5. Spring manual. Verification of date of purchase may be required for warranty service of your HOOVER product. MFG Code
  • Hoover C1810020 | Manual - Page 3
    feet and all parts of body away from openings, rotating agitator and other moving parts. • Do Hoover Factory Service Center or Authorized Hoover Commercial Warranty Service Distributor. • Use only as described in this manual. Use only manufacturer's recommended attachments. SAVE THESE INSTRUCTIONS
  • Hoover C1810020 | Manual - Page 4
    following the above steps, your cleaner may need servicing. Note: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code. Consignes de mise à la terre 1 B Cet installed and grounded in accordance with all local codes and ordinances. Grounding Instructions 4
  • Hoover C1810020 | Manual - Page 5
    on both sides of the nozzle to remove embedded dirt in carpet near baseboards and furniture. Guide either side of the nozzle parallel to edge of carpet or furniture. 2. MAINTENANCE Disconnect cleaner from electrical outlet before attempting to service it in any manner. Do not operate cleaner without
  • Hoover C1810020 | Manual - Page 6
    the inside of the outer bag must be attached over the top-fill tube when using a paper throw away bag. Optional Paper Throw Away Bag A HOOVER® Type A paper throw away bag may be used with the cleaner in place of the cloth dirt bag. Remove cloth dirt bag from cleaner following
  • Hoover C1810020 | Manual - Page 7
    en les tirant vers l'extérieur comme il est illustré. Retirer le vide‑poussière et le vider. Replacer le vide‑poussière dans le support au bas du sac et verrouiller les languettes en position. 2.6 FULL LINE Las courroies Quand remplacer Débrancher l'appareil avant de vérifier ou de remplacer la
  • Hoover C1810020 | Manual - Page 8
    screws. Tighten screws with screwdriver. Belts: What to Buy Use only genuine HOOVER belts with your cleaner. When purchasing a new Flat Belt, ask for HOOVER part No. 38528036. When purchasing a new V-Belt, ask for HOOVER part No. 38528013. 2.12 A Turn cleaner over. Place V-belt into groove of
  • Hoover C1810020 | Manual - Page 9
    Agitator Roll Sleeve: What to Buy Use only genuine HOOVER agitator roll sleeves with your cleaner. For the Conquest 14, ask for HOOVER part No. 48416013. For the Conquest 18, ask for HOOVER part No. 48416017. If agitator does not rotate, the V-belt is not positioned properly in the groove of the
  • Hoover C1810020 | Manual - Page 10
    a Hoover Sales and Service Center or an Authorized Hoover Warranty Service Dealer. Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Sales and Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under "Vacuum
  • Hoover C1810020 | Manual - Page 11
    www.hoover.com Repase por favor este manual antes de funcionar su aplicación de Hoover®. Esta aspiradora cumple con los requisitos de la Ley de seguridad y salud ocupacional (Occupational Safety and Health Act, OSHA; Título 29 Sección 1910 Inciso S del Código Federal de Reglamentaciones [Code of
  • Hoover C1810020 | Manual - Page 12
    este manual del usuario. Para obtener el servicio de garantía de compra de su producto HOOVER, es posible que se requiera la verificación de la fecha de compra. MFG Code Descripción de la aspiradora 1. Cubierta 2. Tapa de acceso: Permite acceder al canal para polvo para eliminar las partículas
  • Hoover C1810020 | Manual - Page 13
    Service (Mantenimiento) de Hoover Inc., en Internet en www.hoover.com No envíe su aspiradora a Hoover , los pies y todas las partes del cuerpo fuera de las aberturas Hoover o Distribuidor de servicio de garantía comercial autorizado de Hoover. • Use el producto sólo como se describe en este manual
  • Hoover C1810020 | Manual - Page 14
    Eléctrico Canadiense (Canadian Electrical Code) no permite el uso de . Mueva el agitador hacia la parte posterior de la aspiradora. Vuelva HOOVER genuinas con su aspiradora. Para el Conquest 14, solicite la pieza n° 48416013 de HOOVER. Para el Conquest 18, solicite la pieza n° 48416017 de HOOVER
  • Hoover C1810020 | Manual - Page 15
    afuera y deslice la correa usada. 2.11 C A B Con la inscripción hacia la parte exterior de la correa nueva en V, coloque la correa en la acanaladura de la polea la pieza n° 38528036 de HOOVER. Al comprar una nueva correa en V, solicite la pieza n° 38528013 de HOOVER. Apriételos con un
  • Hoover C1810020 | Manual - Page 16
    usar una bolsa desechable de papel tipo A de HOOVER® con la aspiradora en lugar de una bolsa de clip de cierre de la bolsa dentro de la parte superior de la bolsa exterior y conecte el anillo de el depósito y vacíelo. Reposition cup up into support at bottom of bag and snap latches into position.
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

www.hoover.ca
Manuel du Propriétaire
Notice d’utilisation et d’entretien
©
2008
Tous droits réservés
. #59156659 R0. 10/08
Veuillez lire attentivement ces instructions avant d’utiliser votre appareil Hoover
MD
.
Cet appareil est conforme aux exigences de la Loi sur la santé et la sécurité au travail
(29 CFR 1910, sous paragraphe S).
Please review this manual before operating your Hoover® appliance.
www.hoover.com
Owner’s Manual
Operating and Servicing Instructions
©2008 All rights reserved. #59156659 R0. 10/08
This cleaner meets Occupational Safety and Health Act (OSHA-29 CFR 1910 Subpart S) requirements.