Hoover DOKITCHAPP884827 Manual

Hoover DOKITCHAPP884827 - FloorMate Spin Scrub Manual

Get Hoover DOKITCHAPP884827 - FloorMate Spin Scrub PDF manuals and user guides
UPC - 961613026286
View all Hoover DOKITCHAPP884827 manuals
Add to My Manuals
Save this manual to your list of manuals

Hoover DOKITCHAPP884827 manual content summary:

  • Hoover DOKITCHAPP884827 | Manual - Page 1
    ENGLISH § pp. 1-20 ESPAÑOL § pág. 21-36 FRANÇAIS § p. 37-52 FloorMate™ SpinScrub™ 800 Hard Floor Cleaner www.hoover.com ®
  • Hoover DOKITCHAPP884827 | Manual - Page 2
    outlet only. See "Grounding Instructions". • Do not clean over floor electrical outlets. • Do not use without tanks in place. • Always install float before any wet pick up operation. • Close supervision is necessary when any appliance is used by or near children. Do not allow cleaner to be used as
  • Hoover DOKITCHAPP884827 | Manual - Page 3
    the brushes 17 Troubleshooting 18 Service 19 Warranty 20 Carton Contents A. Hard floor cleaner B. Nozzle C. Upper handle D. Brush assemblies (2) E. Tool caddy F. Floor swivel tool G. Grout tool H. Telescoping wand I. Hose J. Floor cleaning concentrates © 2004 The Hoover Company www.hoover.com
  • Hoover DOKITCHAPP884827 | Manual - Page 4
    Cleaner Description 1 1 2 3 17 16 15 4 4 5 6 7 8 9 10 11 20 12 11 14 13 Features 1. Soft hand grip 2. ON/OFF switch 3. Solution trigger: squeeze to release cleaning solution 4. Mode selector dial: turns brushes ON for wet cleaning and OFF for wet pickup and dry vacuuming 5. Clean solution
  • Hoover DOKITCHAPP884827 | Manual - Page 5
    on upper 3 handle (C) with slot in bottom handle support (D). 4 Push upper handle (C) down until it is snapped in place. Install brushes and nozzle 5 To install brushes, place handle in upright position. Tilt cleaner back so that it rests on the floor. Align post (A) on brush block with hole
  • Hoover DOKITCHAPP884827 | Manual - Page 6
    (D) of nozzle with opening (E) on cleaner. Remove cardboard packing insert from squeegee area on underside of nozzle. 8 While holding nozzle in place, slide latches inward to lock in place. Assemble tool caddy 9 The two sections (A & B) of the tool
  • Hoover DOKITCHAPP884827 | Manual - Page 7
    back of caddy. Place floor swivel tool (K), grout tool (L), brush assembly (M), telescoping wand (N) and detergent (O) into caddy as shown. Unfold handle 12 Raise upper handle (A) to upright position until it locks OFF switch 15 Push switch (A) once to turn cleaner ON. Push switch again to turn
  • Hoover DOKITCHAPP884827 | Manual - Page 8
    may also be lifted using the carrying handle (A) on the front of the cleaner. 16 17 A General operation Your HOOVER FloorMate™ SpinScrub™ 800 Cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile, marble and sealed wood. It is not intended
  • Hoover DOKITCHAPP884827 | Manual - Page 9
    included with your FloorMate™ SpinScrub™ 800 Cleaner. Use these for tile floors where extra attention is needed for cleaning grout. (See "Cleaning the brushes" section for how to remove and replace the brush assemblies.) Using cap (A), measure 1-1/2 capfuls (3 oz.) of HOOVER® Grout Cleaner. DO NOT
  • Hoover DOKITCHAPP884827 | Manual - Page 10
    25 and to prevent leaking. 26 26 Slide tank straight into position until latch snaps in place. Recovery (lower) tank Automatic shut-off An automatic suction shut-off is built into the recovery tank to prevent the tank from overflowing. When the shut-off activates, the cleaner will not pick up
  • Hoover DOKITCHAPP884827 | Manual - Page 11
    be emptied after dry vacuuming and before wet operation. Check the solution tank also. It may need to be refilled at this time. 27 To remove tank, press down on release button (B) and pull tank straight out. 28 Remove tank lid (C). Empty tank. To clean filters The tank lid contains a washable
  • Hoover DOKITCHAPP884827 | Manual - Page 12
    tank, place bottom of tank behind ledge (E) and push tank straight into cleaner body until it is locked in place. E How to clean Recommended cleaning sequence Use your HOOVER® FloorMate™ SpinScrub™ 800 Cleaner to: • Dry Vacuum to remove loose dirt, hair and debris. • Wet Clean the floor
  • Hoover DOKITCHAPP884827 | Manual - Page 13
    bare wood or separated joints. Do not use FloorMate™ SpinScrub™ cleaner to wet clean sealed wood floors if any of these conditions exist. 1 Set Mode selector dial to DRY VAC position and vacuum floor. Turn cleaner off and disconnect from electrical outlet. Empty recovery tank (see Figs. 27 2 and 28
  • Hoover DOKITCHAPP884827 | Manual - Page 14
    Using the tools 35 Select tool A. Floor swivel tool • Swivel head • 2 rows of brushes • Use to clean small, tight areas B. Grout tool • Stiff brushes to use for more concentrated cleaning on stubborn grout stains 35 A Attach hose and tool Unplug cleaner from electrical outlet. How to connect hose
  • Hoover DOKITCHAPP884827 | Manual - Page 15
    sure that nothing is pressing on the nozzle squeegee. • Do not store cleaner on a wood surface unless cleaner is completely dry. B 41 E G H I C DF 42 M K J N N L Tool caddy 40 For your convenience, the HOOVER® FloorMate™ SpinScrub™ 800 tool caddy (A) is provided for storing the hose
  • Hoover DOKITCHAPP884827 | Manual - Page 16
    by pulling straight out. 45 Rinse nozzle under running water. Remove debris from squeegee (C) and wipe with a damp cloth. 45 46 To replace nozzle, make sure latches (D) are out. C Cleaner should be in the upright position for easier assem- bly of the nozzle. 46 Align middle section (E) of
  • Hoover DOKITCHAPP884827 | Manual - Page 17
    be removed for easy cleaning. Turn cleaner OFF and disconnect from electrical outlet. Place handle in the upright position. A Remove tanks to prevent leaking. Set aside. 48 Pull the two nozzle release buttons (A) out. Remove nozzle. Tilt cleaner back so handle rests on floor. 49 Push two brush
  • Hoover DOKITCHAPP884827 | Manual - Page 18
    Model selector dial to ensure it is set for DRY VAC.  Tip nozzle off floor by pushing down on handle to pick up debris that is too large to clear the squeegee.  Make sure solution tank is locked in position.  Refill the solution tank if it is empty.  Pump needs to be primed (when using tool
  • Hoover DOKITCHAPP884827 | Manual - Page 19
    Authorized Hoover Warranty Service Dealer (Depot) by:  Checking the Service Section of The Hoover Company on-line at www.hoover.com OR  Checking the list of Factory Service Centers provided with this cleaner OR  Checking the Yellow Pages under "Vacuum Cleaners - Household" OR  Calling 1-800-944
  • Hoover DOKITCHAPP884827 | Manual - Page 20
    (Domestic Use) Your HOOVER® appliance is warranted in normal household use, in accordance with the Owner's Manual against original defects in material and workmanship for a period of one full year from date of purchase. This warranty provides, at no cost to you, all labor and parts to place this
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
ENGLISH
pp. 1-20
ESPAÑOL
pág. 21-36
FRANÇAIS
p. 37-52
www.hoover.com
®
FloorMate™
SpinScrub™ 800
Hard Floor Cleaner