Hoover F4300 Manual - Page 4
How to use - floor polisher
View all Hoover F4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Connect handle Remove tank from shampoo-polisher and remove nut, bolt and cord clip from top of lower handle section. 1-3 1-4 2. How to use Polarized plug To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. Join upper and lower handles, lining up holes. Place cord clip around cord with flat side toward handle and holes to front. Insert bolt through cord clip and through small holes of handle; secure with nut. Pull up slack in cord and tighten nut with screwdriver. Attaching and removing brushes and pads Disconnect from electric circuit before putting on or removing brushes. Place shampoo-polisher upside down on flat surface. 2-1 2-2 ON-OFF switch The floor machine's ON-OFF switch is internal and is operated by lowering and raising the handle. Be sure handle is in lock (upright) position before connecting power cord to wall outlet. Start floor machine by pressing handle release lever and lowering handle. Raise handle to lock position to stop floor machine. A To attach brushes Press each brush down firmly over brush shaft (A), rotating brush until it clicks into position. To remove-grasp center of brush with thumb and fingers and lift up. To attach pads Insert end of fastener through opening in pad. Place pad over power scrub and cleaning brushes only. The fastener fits around the brush shaft. Press the fastener to snap into place. Unsnap fastener to remove pad. 2-3 2-4 2-5 Attaching tank Attach brushes and pads before attaching tank. Set bottom of tank into tank support. 4 Turn tank cap lock until the rivet is directly above slot. Raise tank cap lock and tank cap. Snap tank against handle. Push tank cap down. Slide cap lock down and turn right or left to lock tank and cap into position.