Hoover F4300 Manual - Page 9
If you have a, problem - canada
View all Hoover F4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3-2 Storage Wrap cord around cord storage hook located at the bottom of the tank housing, and then around the trigger. Store your floor machine in a cleaning closet or convenient place, ready for use. Hang it on the wall or remove brushes and store it with the handle in the upright position. Never store it on the brushes. 4. If you have a problem If a minor problem occurs it usually can be solved quite easily when the cause is found by using the check list below. Problem: Floor machine won't run Possible cause Possible solution • Not firmly plugged in • Plug in firmly • No voltage in wall plug • Check fuse or breaker • Blown fuse/tripped breaker • Replace fuse/reset breaker Problem: Floor machine won't dispense solution Possible cause Possible solution • Tank valve clogged. • Unscrew cap on bottom of tank and rinse cap with water to clear blockage. Problem: Floor machine does not glide easily Possible cause Possible solution • Brushes and pads not properly attached. • Attach brushes and pads properly. • Accumulation of wax on felt pads. • Wash and dry pads thoroughly. Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under "Vacuum Cleaners - Household" OR - • checking the list of Factory Service Centers provided with this cleaner OR - • calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) OR - • checking the Service section of The Hoover Company on-line at www.hoovercompany.com Please do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay. If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone: 1-330-499-9499. In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone: 1-800-263-6376. Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the rear wheel cover.) Servicing of double- insulated appliances This appliance is double insulated. In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added. Servicing a double-insulated appliance requires extreme care and knowledge of the system, and should be done only by qualified service personnel. Replacement parts must be identical to those parts being replaced. A doubleinsulated appliance is marked with the words "DOUBLE-INSULATION" or "DOUBLE INSULATED". The symbol may also be marked on the appliance. Lubrication The motor is equipped with two sleeve bearings. These bearings contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing. 9