Hoover F5810 Manual - Page 10
How to attach bare floor cleaning tool - hose
UPC - 719881157764
View all Hoover F5810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
HANDLE RELEASE PEDAL Step on handle release pedal and lower carpet cleaning machine handle until it rests on the floor. Unlatch back part of recovery tank lid and remove lid. FRONT PANEL Remove recovery tank front panel by sliding it straight up. HOSE CONNECTOR Replace panel with hose connector. Slide connector down until it snaps firmly in place. SOLUTION TUBE TABS The tank lid replaces in a hinge-like manner. Position front of lid under tabs on front of tank. Rotate lid down onto tank. Make sure lid is secure on all sides before cleaning. Raise carpet cleaning machine handle to upright position. Reverse procedure to remove hose and solution tube. Follow the instructions on page 11 for the appropriate cleaning task. Disconnect carpet cleaning machine from electrical outlet. Disconnect hose and solution tube from carpet cleaning Follow the instructions for "After cleaning" on page 8. Drain suction hose by turning carpet cleaning machine on and holding nozzle up for several minutes. Do not squeeze trigger. machine. Drain solution tube by placing round end in sink, and raising nozzle and all tubing above your head. Squeeze the trigger. Replace recovery tank front panel. Slide panel down until it snaps firmly into place. Before connecting tube to cleaner, make sure black tabs are extended by pulling tan collar toward tube. Open door on hood labeled "Stair/upholstery cleaning connection". Press round solution tube connector onto round projection inside door. Press connector collar down firmly to ensure that it is fully connected. 10 Using stair/upholstery nozzle Make sure lower recovery tank lid is properly positioned. How to attach bare floor cleaning tool