Hoover F5810 Manual - Page 12
Storage, If you have a problem, Lubrication, Service - replacement parts
UPC - 719881157764
View all Hoover F5810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
If you have a problem This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this check list is provided for your convenience. Possible cause Machine won't run 1. Not firmly plugged in. 2. No voltage in wall plug. 3. Blown fuse/tripped breaker. Possible solution 1. Plug unit in firmly. 2. Check fuse or breaker. 3. Replace fuse/reset breaker. Low suction 1. Recovery tank lid not 1. Make sure lid is on on correctly. securely (page 7). 2. Recovery tank full/ 2. Remove and empty automatic shut-off recovery tank. engaged. 3. Obstruction in hose 3. Remove hose; clear on stair/upholstery obstruction. nozzle. 4. Recovery tank front 4. Replace recovery tank panel not replaced after front panel (page 10). stair or upholstery cleaning. Clean solution won't dispense 1. Solution tank not firmly in place. 2. Solution tank empty. 3. Recovery tank lid not on correctly. 4. Stair/upholstery solution tube not securely fastened. 1. Make sure tank is securely locked in position. 2. Refill tank according to instructions for surface being cleaned (pages 5 & 6). 3. Make sure lid is firmly in place. 4. Make sure tube is securely fastened at connection of hood. Solution tube on stair/upholstery nozzle won't connect 1. Connector collar 1. Extend black tabs on pushed forward. connector by pulling collar towards tube. Storage Before storing: • Empty solution tank and rinse thoroughly with clean water. • Replace empty solution tank and turn deep cleaner ON. Squeeze trigger and push deep cleaner forward and back several times to expel any solution remaining in the deep cleaner's system. (Do not use deep cleaner on wood floors.) • Empty recovery tank and rinse thoroughly with clean water. Allow underside of deep cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood surface. Do not store deep cleaner with a full solution tank in place. Lubrication The motor is equipped with bearings which contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Do not add lubricant to motor bearings. Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under "Vacuum Cleaners- Household" OR- • checking the list of Factory Service Centers provided with this cleaner OR - • calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only). Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay. If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone: 1-800-414-1066. In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone: 1-800-263-6376. Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the back of the cleaner handle.) HOOVER and are registered trademarks THE HOOVER COMPANY, NORTH CANTON, OHIO 44720 R4 2-96 F5805/15/17/25/27/31/33 12 Litho USA 56518-080