Home » Hoover Manuals » Steam Cleaners » Hoover F7210 » Manual Viewer

Hoover F7210 Manual

View all Hoover F7210 manuals

Add to My Manuals
Save this manual to your list of manuals

Hoover F7210 manual content summary:

Hoover F7210 | Manual - Page 1
™ ™ Deep Cleaner The Easy to Use Deep Cleaner ® ENGLISH § pp. 1-15 ESPAÑOL § pág. 16-25 FRANÇAIS § p. 27-35 SteamVac™ V2™ Deep Cleaner cleans carpet fibers by applying hot tap water and cleaning solution. www.hoover.com
Hoover F7210 | Manual - Page 2
"Grounding Instructions". • Do not clean over floor electrical outlets. • Do not use without tanks in place. • Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center
Hoover F7210 | Manual - Page 3
receipt to this owner's manual. Verification of date of purchase may be required for warranty service of your Hoover product. Contents Important safeguards 2 Parts needed for assembly 3 Assembling deep cleaner 3-5 Deep cleaner description 6 General operation 6-8 Filling the clean water tank
Hoover F7210 | Manual - Page 4
The assembled cleaner will look like this 1-2 drawing. 1-3 C B A Attach upper handle Remove clean water tank (upper tank) from deep cleaner. NOTE: If the cord protector (A) on back of handle should become dislodged during unpacking, make sure it is repositioned properly before continuing with
Hoover F7210 | Manual - Page 5
top of caddy toward cleaner handle. Slide caddy down so notch (G) on caddy rests in hook (H) on cleaner. J Identify the hose parts before storing hose. I. Nozzle connector end J. Solution hose. Press solution tube (J) into opposite side of clip. 1-15 1-16 1-17 Insert top of bare floor tool (
Hoover F7210 | Manual - Page 6
: press to release cleaning solution 3. ON/OFF switch 4. Wash/Rinse switch 5. Utility tool 6. Carrying handle 7. Clean water tank handle 8. Clean water tank 9. Detergent container 10. Recovery tank handle 11. Recovery tank: holds dirty solution 12. Recovery tank latches 13. Brush setting selector 14
Hoover F7210 | Manual - Page 7
for more details. The tanks Clean water tank (upper tank) The clean water tank (C) holds the water that will either be mixed with detergent for cleaning the carpet or floor, or used to rinse the carpet or floor. The detergent container (D) is permanently attached to the water tank. It holds the
Hoover F7210 | Manual - Page 8
Bare Floor Cleaner. Do not use Bare Floor Cleaner on carpet or upholstery. Do not use any type of wax with your 'SteamVac' deep cleaner. To assure proper results, use only HOOVER detergent. Replace container cap and tighten. Recovery tank (lower tank) The recovery tank holds the dirty solution
Hoover F7210 | Manual - Page 9
area rugs/ carpet to a nonwood bare floor surface or place waterproof material (e.g. plastic) underneath them before cleaning. See pages 10-14 for instructions on various cleaning tasks. *Available at additional cost if not included with your model. After cleaning a. Allow carpet or upholstery to
Hoover F7210 | Manual - Page 10
Rinse ON WASH OFF Carpet Cleaning Read "Before you begin cleaning" instructions on page 9. 1. Fill clean water tank according to instructions for Figs. 2-9 to 2-12. 2. Fill detergent container with HOOVER Carpet/Upholstery Detergent according to instructions for Figs. 2-13 to 2-15. 3. Turn brushes
Hoover F7210 | Manual - Page 11
page 9. Do not use the deep cleaner on hardwood floors. 1. Fill clean water tank according to instructions for Figs. 2-9 to 2-15. 2. Fill detergent container with HOOVER Bare Floor Cleaner according to instructions for Figs. 2-13 to 2-15. 3. Turn brushes ON for scrubbing or OFF if scrubbing is not
Hoover F7210 | Manual - Page 12
3-13 How to attach tool 3-14 J The utility nozzle has a built-in brush to help provide the scrubbing action some spots may need for removal. K Unplug deep cleaner from electrical outlet. 1. Place handle in upright position and remove hose from rack. 2. Connect tool to hose by sliding it onto
Hoover F7210 | Manual - Page 13
9. 1. Attach hose and solution tube as instructed in Figs. 3-10 to 3-12. 2. Place handle in upright position. Agitator brushes will not rotate while handle is in upright position. 3. Fill clean water tank according to instructions for Figs. 2-9 to 2-12. 4. Fill detergent container with HOOVER Carpet
Hoover F7210 | Manual - Page 14
possible leaking, remove clean water tank and recovery tank. Set tanks aside. 4-1 With handle in upright position, tilt cleaner back until handle rests on the floor. 4-2 Grab brush assembly and pull firmly. The brushes can be cleaned under running water. 4-3 B A DB A C To replace brushes
Hoover F7210 | Manual - Page 15
. Problem: Brushes won't rotate during floor cleaning Possible cause Possible solution • Dirty filter screen on bottom of unit • Clean screen as shown in Fig. 3-2 • Setting selector on OFF • Move setting selector to ON Service To obtain approved HOOVER service and genuine HOOVER parts, locate
Hoover F7210 | Manual - Page 16
HOOVER y ®son marcas registradas HOOVER et ®sont des marques déposées R1 11-02 F7210-900 HOOVER and ® are registered trademarks Litho USA 56518-149