Home » Hoover Manuals » Vacuums » Hoover F7222-900 » Manual Viewer

Hoover F7222-900 Manual

Hoover F7222-900 - SteamVac Dual V Steam Vacuum Cleaner Manual

UPC - 719881175812

View all Hoover F7222-900 manuals

Add to My Manuals
Save this manual to your list of manuals

Hoover F7222-900 manual content summary:

Hoover F7222-900 | Manual - Page 1
™ ™ ® ENGLISH § pp. 1-17 ESPAÑOL § pág. 18-27 FRANÇAIS § p. 28-37 Deep Cleaner The Easy to Use Deep Cleaner SteamVac™ Dual V™ Deep Cleaner cleans carpet fibers by applying hot tap water and cleaning solution. www.hoover.com
Hoover F7222-900 | Manual - Page 2
water above 140˚F (60˚C). • Do not point tools toward people or pets. • Use extra care when cleaning on stairs. Do not place deep cleaner on stairs. • Use deep cleaner only for its intended use as described in the instructions. • Use only commercially available Hoover SteamVac™ cleaners intended
Hoover F7222-900 | Manual - Page 3
for warranty service of your Hoover product. Contents Important safeguards 2 Parts needed for assembly 3 Assembling deep cleaner 4-6 Deep cleaner description 7 General operation 7-9 Filling the clean water tank . . . 8-9 Emptying the recovery tank . . . . 9 Brush speed selector 8 Automatic
Hoover F7222-900 | Manual - Page 4
will look like this 1-2 drawing. Model with SpinScrub™ hand tool is shown. 1-3 C B A Attach upper handle Remove clean water tank (upper tank) from deep cleaner. NOTE: If the cord protector (A) on back of handle should become dislodged during unpacking, make sure it is repositioned properly
Hoover F7222-900 | Manual - Page 5
1-9 H 1-10 I 1-11 G Rotate top of caddy toward cleaner handle. Slide caddy down so notch (G) on caddy rests in hook (H) on cleaner. J Identify the hose parts before storing hose. I. Nozzle connector end J. Solution tube I Storing hose and tools Press hose, a few inches from nozzle connector
Hoover F7222-900 | Manual - Page 6
1-18 1-19 Pull tool down and outward. To reposition the tool, reverse this procedure. How to reattach tool cover The tool cover is designed with a breakaway feature which allows it to snap free if it is pushed open too far. To reattach, align hinges of cover with holes on sides of tool storage
Hoover F7222-900 | Manual - Page 7
5. SpinScrub™ hand tool (not included with all models) 6. Carrying handle 7. Clean water tank handle 8. Clean water tank 9. Detergent container 10. Recovery tank handle 11. Recovery tank: holds dirty solution 12. Recovery tank latches 13. Brush setting selector 14. Solution tube connection port 15
Hoover F7222-900 | Manual - Page 8
empty recovery tank before continuing use. Check clean water tank also; it may need to be refilled. Do not use without float and float retainer in place. If broken or dislodged, take to an Authorized Hoover Service Center or Dealer for repair. Brush setting selector Your 'SteamVac' deep cleaner has
Hoover F7222-900 | Manual - Page 9
on carpet or upholstery. Do not use any type of wax with your 'SteamVac' deep cleaner. To assure proper results, use only HOOVER detergent. Replace container cap and tighten. Recovery tank (lower tank) The recovery tank holds the dirty solution that is picked up from the surface being cleaned. When
Hoover F7222-900 | Manual - Page 10
inside recovery tank. 3-2 d. Remove lint from filter screen located on bottom of cleaner as follows. Note: When brushes seem to be rotating slowly, disconnect deep cleaner from electical outlet and check and clean this screen. Remove both tanks as described in Fig. 2-16. Tilt cleaner back so handle
Hoover F7222-900 | Manual - Page 11
position in order for the recovery tank to go on properly. Raise cleaner to upright position and replace clean water tank (Fig. 2-15). Rinse ON WASH OFF Carpet Cleaning Read "Before you begin cleaning" instructions on page 9. 1. Fill clean water tank according to instructions for Figs. 2-9 to 2-12
Hoover F7222-900 | Manual - Page 12
deep cleaner to upright position. Lower handle and replace recovery tank. 5. Raise handle to upright position and reposition clean water tank. To clean floor Read "Before you begin cleaning" instructions on page 9. Do not use the deep cleaner on hardwood floors. 1. Fill clean water tank according
Hoover F7222-900 | Manual - Page 13
SpinScrub™ hand tool (in place of brush module). Can be used to scrub stubborn areas such as scuff marks, dried spills, and in hard to reach areas on hard surfaces. How to attach tools 3-14 J K Unplug deep cleaner from electrical outlet. 1. Place handle in upright position and remove hose from rack
Hoover F7222-900 | Manual - Page 14
to 3-12. 2. Place handle in upright position. Agitator brushes will not rotate while handle is in upright position. 3. Fill clean water tank according to instructions for Figs. 2-9 to 2-12. 4. Fill detergent container with HOOVER Carpet/Upholstery Detergent according to instructions for Figs 2-13 to
Hoover F7222-900 | Manual - Page 15
possible leaking, remove clean water tank and recovery tank. Set tanks aside. 4-1 With handle in upright position, tilt cleaner back until handle rests on the floor. 4-2 Grab brush assembly and pull firmly. The brushes can be cleaned under running water. 4-3 B A DB A C To replace brushes
Hoover F7222-900 | Manual - Page 16
air dry. Replace on deep cleaner. • Unused detergent can be stored in the detergent container. • Empty recovery tank, rinse tank and lid thoroughly with clean water and let air dry. Allow brushes and underside of deep cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood
Hoover F7222-900 | Manual - Page 17
by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.) Full One Year Warranty (Domestic Use) Your HOOVER® appliance is warranted in normal household use, in accordance with the Owner's Manual against original defects