Hoover F7410 Manual

Hoover F7410 Manual

Hoover F7410 manual content summary:

  • Hoover F7410 | Manual - Page 1
    ™ ™ ENGLISH ➜ pp. 1-17 ESPAĄOL ➜ pág. 18-28 Carpet Cleaner The Easy to Use Carpet Cleaner HOOVER® SteamVac™ carpet cleaner cleans carpet fibers by applying, scrubbing and removing hot tap water and cleaning solution. www.hoover.com
  • Hoover F7410 | Manual - Page 2
    Instructions". • Do not clean over floor electrical outlets. left outdoors, or dropped into water, take it to a Hoover Sales and Service Center or Authorized Hoover Warranty Service Dealer. • Close supervision is necessary when any appliance is used by or near children. Do not allow carpet cleaner
  • Hoover F7410 | Manual - Page 3
    be required for warranty service of your Hoover product. Contents Important safeguards 2 Parts needed for assembly 3 Assembling carpet cleaner. . . . . 4-6 Cleaner description 6 General operation 7-9 Filling the clean water tank. . . 8-9 Emptying the recovery tank . . . . 9 Brush speed selector
  • Hoover F7410 | Manual - Page 4
    The assembled cleaner will look like this 1-2 drawing. Model with SpinScrub™ hand tool is shown. 1-3 C B A Attach upper handle Remove clean water tank (upper tank) from carpet cleaner. NOTE: If the cord protector (A) on back of handle should become dislodged during unpacking, make sure it is
  • Hoover F7410 | Manual - Page 5
    notch (G) on caddy rests in hook (H) on cleaner. 1-12 1-10 I 1-11 J Identify the hose parts before storing hose. I. Nozzle connector end J. Solution of bare floor tool (available at additional cost if not included with your cleaner) through "loop" on caddy. Slide tool down into place. Snap stair
  • Hoover F7410 | Manual - Page 6
    with all models) 6. Carrying handle 7. Clean water tank handle 8. Clean water tank 9. Detergent container 10. Recovery tank handle 11. Recovery tank: holds dirty solution 12. Recovery tank latches 13. SpinScrub mode selector 14. Solution tube connection port 15. Edge cleaners: provided on
  • Hoover F7410 | Manual - Page 7
    . Check clean water tank also; it may need to be refilled. Do not use without float and float retainer in place. If broken or dislodged, take to an Authorized Hoover Service Center or Dealer for repair. SpinScrub mode selector Your SteamVac™ carpet cleaner has three agitator brush settings. SPILL
  • Hoover F7410 | Manual - Page 8
    turn cap counterclockwise and remove cap. Do not remove detergent container from tank. 2-15 B A C WARNING: Certain oxygenated-type cleaners, such as OxiClean* and TuffOxi** will damage your SteamVac™ detergent container (A), clean water tank (B) or recovery tank (C). Use only HOOVER SteamVac
  • Hoover F7410 | Manual - Page 9
    is full, the automatic shut-off will engage, suction will stop (see page 7), and the tank must be emptied. How to empty Turn carpet cleaner off and unplug from electrical outlet. To prevent possible leaking, remove clean water tank (Fig. 2-10) by pressing down on tank handle and pulling forward; set
  • Hoover F7410 | Manual - Page 10
    traffic areas. If furniture must be replaced before the carpet is dry, place plastic or aluminum foil under legs of furniture so metal slides or wood finishes will not stain the carpet. b. Empty tanks, rinse with clear water and let air dry. Rinse the recovery tank lid and let air dry. Any unused
  • Hoover F7410 | Manual - Page 11
    . Raise cleaner to upright position and replace clean water tank (Figs. 2-16 through 2-19). Carpet Cleaning Read "Before you begin cleaning" instructions on page 9. 1. Fill clean water tank according to instructions for Figs. 2-9 to 2-12. 2. Fill detergent container with Hoover Carpet/Upholstery
  • Hoover F7410 | Manual - Page 12
    . Lower handle and replace recovery tank. 5. Raise handle to upright position and reposition clean water tank. To clean floor Read "Before you begin cleaning" instructions on page 9. Dhaorndowtouosdefltohoercs.arpet cleaner on 1. Fill clean water tank according to instructions for Figs. 2-9 to
  • Hoover F7410 | Manual - Page 13
    brushes will not rotate while handle is in upright position. 3. Fill clean water tank according to instructions for Figs. 2-9 to 2-12. 4. Fill detergent container with HOOVER H I Drain suction hose by turning carpet cleaner ON and holding nozzle up for several minutes. Do not press trigger. Unplug
  • Hoover F7410 | Manual - Page 14
    Use your carpet cleaner only on upholstery marked "W" or "W/S". 1. Attach hose and solution tube as instructed in Figs. 3-10 to 3-12. 2. Place handle in upright position. Agitator brushes will not rotate while handle is in upright position. 3. Fill clean water tank according to instructions for Figs
  • Hoover F7410 | Manual - Page 15
    using tool" instructions on page 12. 3-23 Removable brushes Your carpet cleaner is equipped with removable brushes for easy cleaning. To remove brushes Disconnect cleaner from electrical outlet. To prevent possible leaking, remove clean water tank and recovery tank. Set tanks aside. With handle
  • Hoover F7410 | Manual - Page 16
    see fol- lowing instructions) 1. Remove clean water tank. 5-1 A A 2. Turn valve cap (A) counterclockwise and remove. Soak valve cap in warm water for at least 15 minutes. Wipe cap dry. 5-2 C B 3. Align slots (B) on cap with tabs (C) in opening. Turn cap clockwise to tighten. Problem: Brushes won
  • Hoover F7410 | Manual - Page 17
    . com This warranty does not cover pick up delivery, or house calls; however, if you mail your appliance to a Hoover Sales and Service Center for warranty service, transportation will be paid one way. While this warranty gives you specific legal rights, you may also have other rights which vary from
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17

HOOVER
®
SteamVac™ carpet cleaner cleans carpet fibers by
applying, scrubbing and removing hot tap water and cleaning
solution.
www.hoover.com
ENGLISH
pp. 1-17
ESPAĄ
OL
pág. 18-28
The Easy to Use
Carpet Cleaner
Carpet Cleaner