Hoover H3060 Manual - Page 18
Troubleshooting - model
UPC - 073502027998
View all Hoover H3060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Troubleshooting Use the list below to help solve minor problems. What's the problem? Cleaner won't run Low suction Water puddling behind cleaner Won't pick up dirty solution Cleaner pushes a line of dry debris in front of it Cleaning solution won't dispense Brushes won't rotate 18 What to do Make sure the cleaner is plugged in firmly. Check the fuse or breaker. Empty the recovery tank; it may be full and the automatic shut-off engaged. Make sure filter and filter lid are properly positioned. Make sure tanks are locked in place. Check the filter and clean if dirty. Make sure nozzle is replaced properly and locked. Make sure the hose door is closed tightly when not using the hose. Use recommended detergents to reduce excess foaming. Make sure solution tank is installed properly. Empty recovery tank. Check Mode selector dial to ensure it is set for WET PICKUP. Make sure recovery tank is installed properly. Empty recovery tank. Make sure filter and filter lid are properly positioned. Check Model selector dial to ensure it is set for DRY VAC. Tip nozzle off floor by pushing down on handle to pick up debris that is too large to clear the squeegee. Make sure solution tank is locked in position. Refill the solution tank if it is empty. Pump needs to be primed (when using tool). See page 15. Check Mode selector dial to ensure it is set for WASH. Reset circuit breaker. (1) Push ON/OFF switch to turn cleaner OFF. (2) Unplug the cleaner. (3) Wait one minute. (4) Plug the cleaner into electrical outlet. (5) Push the ON/OFF switch again to turn cleaner ON. If the brushes continue to stall and the breaker trips again, clean the brushes to remove debris.