Hoover H3060 Manual - Page 9

20 21 A The tanks Solution (upper) tank The solution tank holds detergent and water that is to be dispersed onto the surface being cleaned. How to fill Disconnect cleaner from electrical outlet. Place cleaner handle in upright, locked position. 20 To remove tank, squeeze release button and pull tank straight out. Carry tank to a sink. 21 Rotate tank cap counter-clockwise and lift up to remove cap (A). 22 22 Turn cap (A) upside down to serve as a measuring cup. A For hard surface floors such as vinyl, linoleum, laminate wood, polyurethane sealed wood or other wood floors that can normally be cleaned using water, use one cap (2 oz.) HOOVER® Floor to Floor™ Cleaner. Check for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water to clean floor. When cleaning ceramic and other tiles, use the set of grout brushes with gray bristles included with your FloorMate™ SpinScrub™ 800 Cleaner. Use these for tile floors where extra attention is needed for cleaning grout. (See "Cleaning the brushes" section for how to remove and replace the brush assemblies.) Using cap (A), measure 1-1/2 capfuls (3 oz.) of HOOVER® Grout Cleaner. DO NOT use cleaning concentrates that contain solvent based ingredients. CAUTION: HOOVER® Floor to Floor™ Cleaning Concentrate and HOOVER® Grout Cleaner cannot be used in Hoover SteamVac™ products. Doing so could damage your SteamVac™ Cleaner. 23 B C 23 Pour cleaning concentrate into tank (B). Fill tank to fill line (C) (1 quart) with warm water. Continued § 9