Home » Hoover Manuals » Vacuums » Hoover U8181 » Manual Viewer

Hoover U8181 Manual

View all Hoover U8181 manuals

Add to My Manuals
Save this manual to your list of manuals

Hoover U8181 manual content summary:

Hoover U8181 | Manual - Page 1
TM Upright Vacuum Cleaner by HOOVER Owner's Manual ENGLISH § pp.1-12 ESPAÑOL § pág. 14-21 FRANÇAIS § p. 23-30 Thank you for your purchase! www.hoover.com ® This product was designed for easy assembly (see page 3)
Hoover U8181 | Manual - Page 2
, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot). • Use vacuum cleaner only for its intended use as described in the instructions. Use only attachments recommended by The Hoover Company; others may cause hazards. Save these
Hoover U8181 | Manual - Page 3
www.hoover.com. Click on the "Service" button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet on the cleaner. 1-2 EG C A B Empty carton. Find the parts shown above before disposing of packing materials. A. Handle section B. Cleaner body
Hoover U8181 | Manual - Page 4
11 10 20 12 17 14 The assembled cleaner will look like the drawing. 1. Handle 14. Nozzle control knob: 2. Custom Control™ power switch 3. Custom Control™ indicator slide knob to correct setting for height of carpet being cleaned. 15. Furniture guard 4. Tool cover 16. Headlight 5. Dusting
Hoover U8181 | Manual - Page 5
only forward strokes. Edge cleaning Special edge groomers are provided on both sides of the nozzle to remove dirt in carpet near baseboards and furniture. Guide either side of nozzle parallel to edge of carpet or furniture. Continued § 5
Hoover U8181 | Manual - Page 6
in warm water with a detergent. Rinse and air dry before using. 2-14 M N 2-15 2-16 Extra reach hose (available at additional cost) Push Custom Control™ switch to OFF position. Align end of extra reach hose with projections (M) over slots (N) on end of attached hose. Slide hose into slots and
Hoover U8181 | Manual - Page 7
cup or filters in place. Remove cup - Lift up slightly and firmly pull cup straight out. The dirt cup assembly consists of the following parts: Lid (A) Dirt Cup (B) Pre-filter (C) HEPA Cartridge Filter (D) Dirt Opening (E) Handle (F) While the cleaner is in operation, the prefilter screen will stop
Hoover U8181 | Manual - Page 8
pull up on assembly to ensure that it is seated properly in the cup. Ensure that no part of pre-filter screen extends above top edge of dirt cup. Replace lid and return cup to you want to replace this filter, ask for HOOVER part No. 40110009. Do not operate cleaner without the filter in place.
Hoover U8181 | Manual - Page 9
Factory Service Center. 3-19 The edge groomers When to replace The edge groomers, located on both sides of the nozzle, should be replaced when they appear worn. What to buy When purchasing edge groomers, ask for HOOVER part No. 39511009. How to replace 3-17 M M Remove bottom plate Disconnect
Hoover U8181 | Manual - Page 10
Belt replacement Inspect the belt The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt Replace and tighten screws. Replace belt When replacing belt, ask for HOOVER part No. 38528037. 1. Remove bottom plate, belt guard and brush roll as
Hoover U8181 | Manual - Page 11
servicing (see "Service" section). Hoover Cleaning Performance This Hoover Cleaning Performance System is for comparing the relative progressive performance of Hoover Control™ switch set on BARE FLOOR position. • Set switch to carpet position • Agitators are obstructed. • Clear obstruction Problem:
Hoover U8181 | Manual - Page 12
channel (B). Replace belt turbine, brush roll, belt guard and bottom plate. Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under "Vacuum Cleaners
Hoover U8181 | Manual - Page 13
13