Humax CI-8100 User Manual - Page 49

8. Installation ** DiSEqC Input You can select DiSEqC switch. 1. Select DiSEqC Input using the button, and press the OK or button. Select the DiSEqC Swtich using the button, and press the OK button. You can select one option among Tone burst A~B, DiSEqC A~D, DiSEqC A~D for 2.0 and Disable. ** LNB Voltage You can raise the LNB Voltage value (select High ) preparing for the distance between antenna and receiver is further than 60m. Caution: If you set the LNB Voltage value as High when the distance between antenna and receiver is close, the LNB may be damaged. Please be careful. 1. Select LNB Voltage using the or button. button, and press the OK 2. Set the LNB Voltage value using the button, and press the OK button. ** Standard If the distance between antenna and receiver is ** within 60m High If the distance between antenna and receiver is further than 60m 3. If you change the setting value to High a message will prompt you to confirm. Select Yes and press the OK button. When the value is set to High , 1V higher than LNB voltage is supplied to LNB. GB 48