Humax F2-1000T User Manual - Page 43

8. Installation ** This chapter describes how to search for channels and a series of procedures. 8.1 Automatic Search If your receiver is connected to the aerial and television, you can automatically search channels without entering any other information. 1. Select MENU button. 2. Select Installation using the OK or button. button, and press the 3. Select Automatic Search from Installation menu using the button, and press the OK or button. 4. Receiver starts to search channels automatically. ** Search Wait while the receiver searches for the channels, this may take a few minutes. 1. During operating search, the cursor is located at Stop Therefore, if you press the OK button during searching, the operation is stopped and the channels found until then will be displayed. 2. If search operation is successfully completed, and the channel does not exist, press the OK button and try to reset the search operation again if necessary. 3. You can delete unnecessary channels from the searched channels. Select your desired channels to delete and press the OK button. Then select Delete and press the OK button. To delete all channels, select Select All to select all channels, select Delete, and press the OK button. 4. When completing Channel Search and deleting unnecessary channels, select Save to save the changes. GB 43