Humax F4-FOXT User Manual - Page 47

8. Installation This chapter describes how to search for channels and a series of procedures. 8.1 Automatic Search If your receiver is connected to the aerial and television, you can automatically search channels without entering any other information. 1. Press the MENU button. 2. Select Installation using the / button, and press the OK or button. 3. Enter the password using the NUMERIC(0-9) buttons. 4. Select Automatic Search from Installation menu using the / button, and press the OK or button. 5. Receiver starts to search channels automatically. Note: The default password is 0000. If you have forgotten your password, please contact your local product distributor. 1. Search Wait while the receiver searches for the channels, this may take a few minutes. 1. During operating search, the cursor is located at Stop. Therefore, if you press the OK button during searching, the operation is stopped and the channels found until then will be displayed. 2. If search operation is successfully completed, and the channel does not exist, press the OK button and try to reset the search operation again if necessary. GB46 User's Manual