Humax HDCI-2000T User Manual - Page 57

11. Software Update 11. Software Update In order to maintain proper performance of the product, it is essential to have the most up-to-date software. Visit the Humax website to check the latest news and newly released software versions. ** http://www.humaxdigital.com. ** It is recommended that you periodically check for the availability of software update. 11.1 OTA (Over the Air) OTA, an abbreviation of Over-the-Air, is a standard for the transmission of software through a broadcast system. OTA is simply an alternative method for downloading software versions. However, the manufacturers reserve the right for deciding the release of the software for their products by beaming the latest software versions over the air via aerial. The software update via aerial will only occur under the following circumstances. 1. The equipment should have appropriate loader software. Caution: Please note that if normal loader software is not equipped, the product may not be updated or operate properly after software update. ** 2. The manufacturer decides to release the software via a designated channel. 3. The equipment must be tuned properly to the same aerial equivalent to that of the manufacturer. 4. Update software when the signal strength and quality is high. If the signal strength and quality are not recommendable, perform the software update later. Caution: • Please be careful to keep the Power ON and the power cord plugged in during software update. If the power is off during software update, fatal damage may be caused to the product. • Please be careful not to pull out the signal line (coaxial cable) during software update. Update may be interrupted and the product may not operate. Note: • Other functions will not activate while software update takes place. • It may take 5~10 minutes to update software. • Scheduling operation cannot work during software update. 1. When new software is detected via OTA 1. A message will pop up when powering on to notify that software update is available. 2. Select Immediate and press the OK button to perform software update immediately. 3. Select Later and press the OK button to update the software later. GB 56