Husqvarna 11524E Owners Manual

Husqvarna 11524E Manual

Husqvarna 11524E manual content summary:

  • Husqvarna 11524E | Owners Manual - Page 1
    's Manual 11524E / 96193007400 532 44 35-00 Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. Please read the owner's manual carefully and make sure you understand the instructions
  • Husqvarna 11524E | Owners Manual - Page 2
    spark plug, disconnect the cord on electric motors, thoroughly inspect the snow (d) Never fill containers inside a vehicle or on a truck thrower for any damage, and repair the damage before or trailer bed with a plastic liner. Always place restarting and operating the snow thrower. containers
  • Husqvarna 11524E | Owners Manual - Page 3
    Spark Plug: Gap: Champion RC12YC/694385 0.030" (0,762 mm) CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. • Follow a regular schedule in maintaining, caring for and using your snow thrower. • Follow the instructions under "Maintenance" and "Storage" sections of this owner's manual
  • Husqvarna 11524E | Owners Manual - Page 4
    PARTS PACKED SEPARATELY IN CARTON (1) FUEL STABILIZER PACKET (1) MULTIWRENCH (180684) (1) POWER CORD (198563) SAFTEY IGNITION KEY (S) (193071) (1) DISCHARGE CHUTE (1) AUGER CONTROL ROD EXTRA SHEAR BOLTS AND NUTS (6) SHOULDER BOLT 1/4-20 x 1-3/4 (192090) (6) LOCKNUTS 1/4-20 (73800400)
  • Husqvarna 11524E | Owners Manual - Page 5
    PRE-OPERATION Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower. Reading the entire manual will familiarize you with the unit, which will assist you in assembly, operation and maintenance of the product. Your new snow thrower has
  • Husqvarna 11524E | Owners Manual - Page 6
    ASSEMBLY / PRE-OPERATION INSTALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4) The traction INSTALL AUGER CONTROL ROD (See Figs. 5 and 6) 1. Retrieve vinyl sleeve and spring from bag of parts and retrieve the auger control rod from carton chute tray. Slide straight rod end through the small hole
  • Husqvarna 11524E | Owners Manual - Page 7
    ASSEMBLY / PRE-OPERATION INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD (See Fig. 7) NOTE: The multi-wrench provided in your parts bag may be used to install the chute rotater head. 1. Place discharge chute assembly on top of chute base with discharge opening toward front of snow thrower. 2. Position
  • Husqvarna 11524E | Owners Manual - Page 8
    AND ALL SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with your snow thrower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your snow thrower or in literature supplied with
  • Husqvarna 11524E | Owners Manual - Page 9
    GASOLINE FILLER CAP MUFFLER CHOKE CONTROL OPERATION ELECTRIC START BUTTON AUGER CONTROL LEVER RECOIL ( Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be
  • Husqvarna 11524E | Owners Manual - Page 10
    to disengage. OFF FULL FIG. 13 TO CONTROL SNOW DISCHARGE (See Fig. 14) WARNING: Snow throwers have exposed rotating parts, which can cause severe injury from contact, or from material thrown from the discharge chute. Keep the area of operation clear of all persons, small children and pets at
  • Husqvarna 11524E | Owners Manual - Page 11
    chute may become clogged with ice and snow. Use the clean-out tool to dislodge this blockage. When cleaning, repairing, or inspecting, make certain all controls are disengaged and the auger/impeller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from
  • Husqvarna 11524E | Owners Manual - Page 12
    thrower. • If snow thrower must be operated over gravel surface, use extra caution and be sure skid plates are adjusted to lowest (highest scraper clearance) position. 1. Shut off engine and wait for all moving parts service of this manual. ADD GASOLINE problems Instructions for additional information. Never use
  • Husqvarna 11524E | Owners Manual - Page 13
    shut-off valve is in the "OPEN" position. Your snow thrower engine is equipped with both a 120 Volt A.C. electric starter and a recoil starter. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A.C. household current. • Be sure your house
  • Husqvarna 11524E | Owners Manual - Page 14
    to run for a few minutes to melt snow and ice off the engine. • Clean the entire snow thrower thoroughly after each use and wipe dry so it is ready for next use. WARNING: Do not operate snow thrower if weather conditions impair visibility. Throwing snow during a heavy, windy snowstorm can blind you
  • Husqvarna 11524E | Owners Manual - Page 15
    to properly maintain your snow thrower. At least once a season, check to see if you should make any of the adjustments described in the Service and Adjustments section of this manual. • At least once a year, you should replace the spark plug and check belts for wear. A new spark plug will help your
  • Husqvarna 11524E | Owners Manual - Page 16
    beginning of each season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in the "PRODUCT SPECIFICATIONS" section of this manual. CLEANING IMPORTANT: For best performance, keep snow thrower housing free of any dirt or trash. Clean the outside
  • Husqvarna 11524E | Owners Manual - Page 17
    and all moving parts have completely stopped. 4. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. SNOW THROWER TO ADJUST SNOW THROWER HEIGHT See "TO ADJUST SKID PLATES" and "SCRAPER BAR" in the Operation section of this manual. CHUTE DEFLECTOR The
  • Husqvarna 11524E | Owners Manual - Page 18
    BELT COVER" in this section of this manual. 4. REMOVE ENGINE PULLEY - Remove bolt, flat washer securing pulley to engine crankshaft. Remove outside (auger) pulley only from crankshaft. 5. SEPARATE SNOW THROWER - With your assistant standing in the operating position holding the handles, remove the
  • Husqvarna 11524E | Owners Manual - Page 19
    snug. ENGINE SEE ENGINE MANUAL. CARBURETOR Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 2,134 meters. If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a service center/department. ENGINE SPEED
  • Husqvarna 11524E | Owners Manual - Page 20
    with new spark plug. OTHER • Remove safety ignition key; store it in a safe place. • Do not store gasoline from one season to another. • Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems. • If possible, store your snow thrower indoors and
  • Husqvarna 11524E | Owners Manual - Page 21
    TROUBLESHOOTING See appropriate section in manual unless directed to an authorized service center/department. PROBLEM CAUSE CORRECTION instructed in the Operation section of this manual. 7. Wait a few minutes before restarting, DO NOT prime. 8. Connect wire to spark plug. 9. Replace spark plug
  • Husqvarna 11524E | Owners Manual - Page 22
    &RQVXPHU:KHHOHG3URGXFWV±/LPLWHG:DUUDQW\ +XVTYDUQDZDUUDQWVWRWKHRULJLQDOUHWDLOSXUFKDVHUWKDWWKLV+XVTYDUQDŠSURGXFWLVIUHHIURPGHIHFWVLQPDWHULDORUZRUNPDQVKLS XQGHUQRUPDOXVHDQGPDLQWHQDQFHIURPWKHGDWHRIUHWDLOSXUFKDVHIRUWKHDSSOLFDEOH:DUUDQW\3HULRGVKRZQRQ([KLELW$&
  • Husqvarna 11524E | Owners Manual - Page 23
    F 3UHYHQWDWLYHPDLQWHQDQFHDVRXWOLQHGLQWKHRSHUDWRU¶VPDQXDO ,QDGGLWLRQ\RXPXVWFHDVHXVLQJWKHSURGXFWLPPHGLDWHO\XSRQDQ\IDLOXUHRUGDPDJH7KHSURGXFWVKRXOGEHWDNHQWRDQDXWKRUL]HG +XVTYDUQDVHUYLFLQJGHDOHUSULRUWRDQ\IXUWKHUXVH  'DPDJHV UHVXOWLQJ IURP QRUPDO DJLQJ
  • Husqvarna 11524E | Owners Manual - Page 24
    &RQVXPHU:KHHOHG:DUUDQW\&KDUW ([KLELW$ &RQVXPHU SHUVRQDO &RPPHUFLDO DQ\FRPPHUFLDO 5HQWDO DQ\UHQWDO KRXVHKROGXVHRQO\ SURIHVVLRQDOLQVWLWXWLRQDO XVDJH DULJFXOXWUDORULQFRPHSURGXFLQJ XVHRWKHUWKDQ5HQWDO8VH 3URGXFW&RPSRQHQW 5LGLQJ/DZQ7UDFWRUV )UDPH&KDVVLV
  • Husqvarna 11524E | Owners Manual - Page 25
    &RQVXPHU:KHHOHG:DUUDQW\&KDUW ([KLELW$ &RQVXPHU SHUVRQDO &RPPHUFLDO DQ\FRPPHUFLDO KRXVHKROGXVHRQO\ SURIHVVLRQDOLQVWLWXWLRQDO DULJFXOXWUDORULQFRPHSURGXFLQJ XVHRWKHUWKDQ5HQWDO8VH 3URGXFW&RPSRQHQW )URQW0RXQWHG'HFN5LGHUV (QJLQH   7UDQVPLVVLRQ 
  • Husqvarna 11524E | Owners Manual - Page 26
    SERVICE NOTES 26
  • Husqvarna 11524E | Owners Manual - Page 27
    SERVICE NOTES 27
  • Husqvarna 11524E | Owners Manual - Page 28
    06/14/2011 SR
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

English
532 44 35-00
Operator’s Manual
11524E / 96193007400
Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
Please read the owner's manual carefully and make sure you
understand the instructions before using the machine.