Husqvarna 1830EXLT Owners Manual

Husqvarna 1830EXLT Manual

Get Husqvarna 1830EXLT PDF manuals and user guides View all Husqvarna 1830EXLT manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna 1830EXLT manual content summary:

  • Husqvarna 1830EXLT | Owners Manual - Page 1
    's Manual 1830EXLT Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. 532 44 35-68 Rev. 4 Please read the owner's manual carefully and make sure you understand the instructions
  • Husqvarna 1830EXLT | Owners Manual - Page 2
    adults to operate the equipment without proper instruction. 3. Keep the area of operation clear of all persons, particularly small children. 4. Exercise caution to avoid slipping or falling, especially when operating the snow thrower in reverse. Preparation 1. Thoroughly inspect the area where the
  • Husqvarna 1830EXLT | Owners Manual - Page 3
    , space heaters, or clothes dryers. Allow the engine to cool before storing in any enclosure. 3. Always refer to operator's manual for important details if the snow thrower is to be stored for an extended period. 4. Maintain or replace safety and instruction labels, as necessary. 5. Run the machine
  • Husqvarna 1830EXLT | Owners Manual - Page 4
    16-17 SERVICE AND ADJUSTMENTS 18-20 STORAGE 21 TROUBLESHOOTING 22 WARRANTY 24-27 CONGRATULATIONS on your purchase of a new snow thrower. It has been designed, engineered and manufactured to give best possible dependability and performance. Should you experience any problem you cannot
  • Husqvarna 1830EXLT | Owners Manual - Page 5
    PARTS PACKED SEPARATELY IN CARTON (1) POWER CORD (198563) (1) MULTIWRENCH (180684) (3) RETAINER SPRINGS (169675) (2) FLAT WASHERS (2) SHEAR BOLTS 1/4-20 x 1-3/4 (192090) (2) LOCKNUTS 1/4-20 (73800400) (2) CARRIAGE BOLTS 3/8-16 x 2.25 (2) HANDLE KNOBS SAFTEY IGNITION KEY(S) (443059) (1)
  • Husqvarna 1830EXLT | Owners Manual - Page 6
    thoroughly for additional loose parts. UPPER HANDLE HANDLE KNOB LOWER HANDLE SPEED CONTROL ROD PLASTIC TIE HOW TO SET UP YOUR SNOW THROWER TOOL BOX (See Fig. 10) A toolbox is provided on your snow thrower. The toolbox is located on top of the belt cover. Store the extra shear bolts, nuts and
  • Husqvarna 1830EXLT | Owners Manual - Page 7
    See Figs. 3 and 4) The traction drive control rod is installed on the snow thrower. 1. Remove plastic tie securing rod to lower handle. 2. With top end of rod positioned under left side of control panel, push rod down and insert top end of rod into hole in drive control bracket. Secure with retainer
  • Husqvarna 1830EXLT | Owners Manual - Page 8
    parts bag may be used to install the chute rotator head. 1. Place discharge chute assembly on top of chute base with discharge opening toward front of snow thrower with 1/4-20 shoulder bolt and 1/4-20 locknut as shown. Tighten nut securely. Eyelet will be loose on shoulder bolt. 3. Install spring
  • Husqvarna 1830EXLT | Owners Manual - Page 9
    adjustments. Save this manual for future reference. These symbols may appear on your snow thrower or in literature supplied with the product. Learn and understand their meaning. DANGER OR WARNING PRIMER FORWARD REVERSE READ AND FOLLOW ALL SAFETY INFORMATION AND INSTRUCTIONS BEFORE USE OF THIS
  • Husqvarna 1830EXLT | Owners Manual - Page 10
    - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Freewheel control - disengages transmission for pushing the snowthrower with the engine off. Traction drive control lever - used to engage
  • Husqvarna 1830EXLT | Owners Manual - Page 11
    FIG. 11 SET HEIGHT ADJUSTMENT (See Figs. 12 & 13) Your snow thrower is equipped with a foot controlled height adjustment mechanism (See Fig. 13). This is normal operation. You do not need to add oil to this tank as part of regular maintenance. NOTE: When you receive a new unit that has not been
  • Husqvarna 1830EXLT | Owners Manual - Page 12
    engine. STOPPING TRACTION DRIVE • Release traction drive control lever to stop the forward or reverse movement of the snow thrower. AUGER • Release the auger control lever to stop throwing snow. ENGINE or auger become clogged, shut-off engine and wait for all moving parts to stop. Use the clean-out
  • Husqvarna 1830EXLT | Owners Manual - Page 13
    parts have stopped. Disconnect the spark plug wire and keep the wire away from the spark plug to prevent accidental starting. • Release the auger control lever and shut off the engine a trigger is squeezed, it disengages the track drive on that side of snow thrower and allows it to turn in that
  • Husqvarna 1830EXLT | Owners Manual - Page 14
    , providing additional service before requiring replacement. Replace a damaged or worn scraper bar. TO USE DRIFT CUTTERS (See Fig. 22) Use the drift cutters to cut through deep snowdrifts that are higher than the front of the snow thrower. • Loosen adjustment nuts enough to allow drift cutter
  • Husqvarna 1830EXLT | Owners Manual - Page 15
    path and moving slowly. • Keep engine clean and clear of snow during use. This will help air flow and extend engine life. • After snow-throwing is completed, allow engine to run for a few minutes to melt snow and ice off the engine. • Clean the entire snow thrower thoroughly after each use and wipe
  • Husqvarna 1830EXLT | Owners Manual - Page 16
    must maintain snow thrower as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your snow thrower. All adjustments in the Service and Adjustments section of this manual should be checked at least once each season. • Once a year, you should replace the
  • Husqvarna 1830EXLT | Owners Manual - Page 17
    snow thrower and engine. 6. Install left track (if removed for draining oil). Be sure to install klik pin into hole in axle (See "TO REMOVE TRACKS" in the Service and Adjustments section of this manual and replace corroded muffler as it could create a fire hazard and/or damage. SPARK PLUG Replace
  • Husqvarna 1830EXLT | Owners Manual - Page 18
    damaged, it should be replaced. WARNING: To avoid serious injury, never operate your snow thrower with the deflector removed or damaged. • To change direction and/or distance snow is discharged, see "TO CONTROL SNOW DISCHARGE" in the Operation section of this manual. SHEAR BOLTS (See Fig. 24) AUGER
  • Husqvarna 1830EXLT | Owners Manual - Page 19
    to slip from wear, they should be replaced. It is recommended that the belt(s) be replaced by a service center/department. NOTE: It is recommended that both the auger and traction drive belt be replaced at the same time. The V-belts on your snow thrower are of special construction and should be
  • Husqvarna 1830EXLT | Owners Manual - Page 20
    ENGINE See engine manual. CARBURETOR Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 7,000 feet (2,134 meters). If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center. ENGINE
  • Husqvarna 1830EXLT | Owners Manual - Page 21
    SERVICE AND ADJUSTMENTS NOTE: Fig. 31 shows the bellcrank positioned too high, causing clutch to disengage while driving and giving appearance of When the bellcrank is positioned correctly, replace the plastic power steering cover and the wheel or track. 5. Repeat the procedure for the opposite side.
  • Husqvarna 1830EXLT | Owners Manual - Page 22
    entire snow thrower (See "CLEANING" in the Maintenance section of this manual). 2. Inspect and replace belts, if necessary (See "TO REPLACE BELTS" in the Service and Adjustments section of this manual). 3. Lubricate as shown in the Maintenance section of this manual. 4. Be sure that all nuts, bolts
  • Husqvarna 1830EXLT | Owners Manual - Page 23
    TROUBLESHOOTING See appropriate section in manual unless directed to an authorized service center/department. PROBLEM Does not start Loss of power Engine idles or runs roughly Excessive vibration Recoil starter is hard to pull Loss of traction drive / slowing of drive speed Loss of snow discharge
  • Husqvarna 1830EXLT | Owners Manual - Page 24
    (e.g., engines and transmissions) are excluded from coverage, and other limitations apply, as described in this document. Husqvarna will repair or replace at its discretion, any defective product or part covered by the Limited Warranty, free of charge at any authorized Husqvarna Servicing Dealer
  • Husqvarna 1830EXLT | Owners Manual - Page 25
    model and, if applicable, engine serial number) to an authorized Husqvarna Servicing Dealer for warranty service under this Limited Warranty. Proof of purchase rests solely with you. Husqvarna encourages you to register your product online at www.usa.husqvarna.com (US & Canada) to help ensure, among
  • Husqvarna 1830EXLT | Owners Manual - Page 26
    5 Years No Warranty Engine* * * Transmission (if made by Husqvarna/Peerless) 3 Years Years LE475 Edger, Tillers, Snow Throwers Engine* * Other Non-Expendable Engine* Other Non-Expendable Components* Spreaders * * *2 Years (2nd Year Parts Only) *2 Years-1365GN (2nd Year Parts
  • Husqvarna 1830EXLT | Owners Manual - Page 27
    period applicable to the part or accessory that was replaced. See to left Consumer See to left Commercial See to left Rental * See Separate Engine Manufacturer's or Manufacturer's warranty. LCT Engines on specific Snow Throwers & Tillers, warranty through Husqvarna. ** See reference 1 (b) of
  • Husqvarna 1830EXLT | Owners Manual - Page 28
    08/18/2012 SR
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
English
532 44 35-68 Rev. 4
Operator’s Manual
1830EXLT
Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
Please read the owner's manual carefully and make sure you
understand the instructions before using the machine.