Husqvarna DRT900E Owners Manual

Husqvarna DRT900E Manual

Get Husqvarna DRT900E PDF manuals and user guides View all Husqvarna DRT900E manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna DRT900E manual content summary:

  • Husqvarna DRT900E | Owners Manual - Page 1
    contenant plus de 10 % d'éthanol annulera la garantie du produit. 532 44 80-61 Operator's Manual Owner's Manual DRT900E Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Lisez très attentivement et soyez certain de comprende ces
  • Husqvarna DRT900E | Owners Manual - Page 2
    Powered Rotary Tillers TRAINING • Read the Manual carefully. Be parts have stopped. Disconnect the spark plug wire, and keep the wire away from the plug to prevent accidental starting • Always refer to the operator's guide instructions for important details if the tiller is to be stored for an
  • Husqvarna DRT900E | Owners Manual - Page 3
    any problems you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions will enable you to assemble and maintain your tiller
  • Husqvarna DRT900E | Owners Manual - Page 4
    and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard wrench sizes are listed. (1) Utility knife (1) Tire
  • Husqvarna DRT900E | Owners Manual - Page 5
    TO MOVE Fig. 4 • Rotate handle assembly down. Insert rear carriage bolt first, with bolt head on L.H. side of tiller and loosely assemble locknut (See Fig. 5). • Insert pivot bolt in front part of plate and tighten. • Cut down remaining corners of carton and lay panels flat. • Lower the handle
  • Husqvarna DRT900E | Owners Manual - Page 6
    position (See Fig. 6) • Tilt tiller forward by lifting handle. Separate cardboard cover from leveling shield. • Rotate tiller handle to the right and pull tiller out of carton. CHECK TIRE PRESSURE The operator. (See "TO ADJUST HANDLE HEIGHT" in the Service and Adjustments section of this manual). 6
  • Husqvarna DRT900E | Owners Manual - Page 7
    controls and adjustments. Save this manual for future reference. These symbols may appear on your Tiller or in literature supplied with the Standards Institute. CHOKE CONTROL - Used when starting a cold engine. DEPTH STAKE - Controls depth at which tiller will dig. DRAG STAKE - Controls forward
  • Husqvarna DRT900E | Owners Manual - Page 8
    " position. • Move shift lever indicator to "R" (reverse) position. • Hold tine control against the handle to start tiller move- ment. HARD TO SHIFT GEARS • Briefly engage tine control and release or rock tiller forward and backward until are able to shift gears. DEPTH STAKE (See Fig. 9) The depth
  • Husqvarna DRT900E | Owners Manual - Page 9
    Hold the tine control against the handle to start tiller movement. Tines will not turn. • Service Classification SG-SL. • Reinstall engine oil cap and tighten. • For cold weather operation you should change oil for easier starting (See oil viscosity chart in the Maintenance section of this manual
  • Husqvarna DRT900E | Owners Manual - Page 10
    fuel mixture may need to be adjusted for best engine performance. See "TO ADJUST CARBURETOR" in the Service and Adjustments section of this manual. NOTE: If engine does not start, see troubleshooting points. Choke Control Spark Plug Fuel Shut-Off Valve Throttle Control Recoil Starter Fig
  • Husqvarna DRT900E | Owners Manual - Page 11
    . 14) CAUTION: Until you are accustomed to handling your tiller, start actual field use with throttle in slow position (mid-way tine drive. ADJUST WHEELS FOR CULTIVATING (See Figs. 16 and 17) • Place blocks under right hand side of tiller and remove hairpin clip and clevis pin from right hand wheel
  • Husqvarna DRT900E | Owners Manual - Page 12
    . To receive full value from the warranty, the operator must maintain tiller as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your tiller. All adjustments in the Service and Adjustments section of this manual should be checked at least once each
  • Husqvarna DRT900E | Owners Manual - Page 13
    carburetor adjustment) to prevent accidental starting low on oil. Change the oil after every 25 hours of operation or at least once a year if the tiller is not used for 25 hours in one year. Check the crankcase oil level before starting of this manual. AIR FILTER (See Fig. 20) Service air cleaner
  • Husqvarna DRT900E | Owners Manual - Page 14
    gap setting is shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual. TRANSMISSION Once a season, lubricate the right hand side gear case grease fitting muffler, air filter and carburetor are covered to keep water out. Water in engine will shorten the useful life of your tiller. • Clean engine,
  • Husqvarna DRT900E | Owners Manual - Page 15
    wheel. Pull wheel out from tiller about 1". • Remove two (2) screws from side of belt guard. • Remove hex nut and washer from bottom of belt guard (located behind wheel). • Pull belt guard out and away from unit. • Replace belt guard by reversing above procedure. BELT GUARD SCREW AND WASHER HEX
  • Husqvarna DRT900E | Owners Manual - Page 16
    ON TOP OF IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES. • Check belt adjustment as described below. • Replace belt guard. • Reposition wheel and replace clevis pin and hairpin clip. GROUND DRIVE BELT ADJUSTMENT (See Fig. 25) For proper belt tension, the extension spring should have about 5/8" (16
  • Husqvarna DRT900E | Owners Manual - Page 17
    SERVICE AND ADJUSTMENTS TINE REPLACEMENT (See Figs. 26, 27 and 28) CAUTION: Tines are sharp. Wear gloves or other protection when handling tines. A badly worn tine causes your tiller to work harder and dig more MAX HAIRPIN CLIP SHARP EDGES HAIRPIN CLIP SHARP EDGES SHEAR PIN Fig. 28 17 tine_20
  • Husqvarna DRT900E | Owners Manual - Page 18
    . However, engine performance can be affected by differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, contact your nearest authorized service center/department IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED
  • Husqvarna DRT900E | Owners Manual - Page 19
    TILLER • Clean entire tiller (See "CLEANING" in the Maintenance section of this manual). • Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS THE CARBURETOR, FUEL FILTER, FUEL
  • Husqvarna DRT900E | Owners Manual - Page 20
    TROUBLESHOOTING POINTS PROBLEM Will not start CAUSE 1. Out of fuel. 2. Engine not "CHOKED" properly. 3. Engine flooded. 4. Dirty air cleaner. 5. Water in fuel. 6. Clogged fuel tank. 7. Loose spark plug wire. 8. Bad spark plug or improper gap. 9. Carburetor out of adjustment. CORRECTION 1. Fill
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
English
532 44 80-61
Operator’s Manual
Owner's Manual
DRT900E
Gasoline containing up to 10% ethanol (E10) is accept-
able for use in this machine.
The use of any gasoline ex-
ceeding 10% ethanol (E10) will void the product warranty.
Vous pouvez utiliser de l’essence contenant jusqu’à
10 % d’éthanol (E10) avec cet appareil. L’utilisation
d’essence contenant plus de 10 % d’éthanol annulera
la garantie du produit.
Please read the operator's manual carefully and make sure
you understand the instructions before using the machine.
Lisez très attentivement et soyez certain de comprende ces
instructions avant d’utiliser cette machine