Husqvarna PZ 60 Owners Manual

Husqvarna PZ 60 Manual

Get Husqvarna PZ 60 PDF manuals and user guides View all Husqvarna PZ 60 manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna PZ 60 manual content summary:

  • Husqvarna PZ 60 | Owners Manual - Page 1
    SPARK PLUG WIRES FROM THE SPARK PLUGS. WARNING! Blades are sharp. Protect your hands with gloves and/or wrap blades with a heavy cloth when handling. 1. Block the front of the mower up to give access to the underside of the front deck. Remove the discharge chute assembly by removing the hardware
  • Husqvarna PZ 60 | Owners Manual - Page 2
    INSTALLATION INSTRUCTIONS 5. Set the left hand baffle in place, with weld bolt up through the deck. Secure baffle to deck with nuts and bolts as shown. Attach right hand baffle with the same procedure. 6. Fasten the mulch cap to the deck and baffle. P/N 115 247027 R1 08/15/09
  • Husqvarna PZ 60 | Owners Manual - Page 3
    INSTRUCTIONS 7. Install the kit mulching blades using the existing blade bolt (torque to 90 ft./lbs.). 8. Rotate the blades by hand and check for clearance of all baffles. 9. Make sure all hardware is tight. 10. Remove blocks and return the mower height is 3", the mower deck cutting height should be
  • 1
  • 2
  • 3
P/N 115 247027 R1
08/15/09
INSTALLATION INSTRUCTIONS
1
1
2
2
60" MULCH KIT - 966 444701
IMPORTANT: BEFORE PROCEEDING, PLACE ALL CONTROLS IN
THE
DISENGAGED
OR
OFF
POSITION, REMOVE SPARK PLUG
WIRES FROM THE SPARK PLUGS.
WARNING!
Blades are sharp. Protect your hands
with gloves and/or wrap blades with a
heavy cloth when handling.
Block the front of the mower up to give access
1.
to the underside of the front deck. Remove the
discharge chute assembly by removing the
hardware (1) on the bracket top. Set the assembly
and hardware aside for reinstallation when the
mulch kit is not being used.
Remove the three nuts and bolts that protect the
2.
mulch kit fastening locations (2).
NOTE: Only two hardware sites are shown in the
illustration.
Carefully remove the cutting blades, retaining the
3.
blade bolts for reuse. Clean any grass out from
underneath the deck.
Bolt left hand corner mulch baffle to the
4.
outside
of the deck baffle weldment as shown in the
illustration.