Husqvarna ST 151 Owners Manual

Husqvarna ST 151 Manual

Get Husqvarna ST 151 PDF manuals and user guides View all Husqvarna ST 151 manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna ST 151 manual content summary:

  • Husqvarna ST 151 | Owners Manual - Page 1
    Operator's Manual ST 151 Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. 115 68 51-27 Please read the owner's manual carefully and make sure you understand the instructions
  • Husqvarna ST 151 | Owners Manual - Page 2
    problem you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions will enable you to assemble and maintain your snow thrower
  • Husqvarna ST 151 | Owners Manual - Page 3
    00000000 000 000 000 0000 FOR SERVICE CALL/POUR APPELER LE SERVICE 1-800-448-7543 ASSEMBLED IN snow thrower. • Follow the instructions under "Maintenance" and "Storage" sections of this manual. PRODUCT SPECIFICATIONS Gasoline Capacity 1.6 Quarts (1,5 Liters) and Type: Unleaded Regular only Oil
  • Husqvarna ST 151 | Owners Manual - Page 4
    AND INSTRUCTIONAL DECALS 4 ASSEMBLY 5-6 PRODUCT OVERVIEW 7 OPERATION 8-11 MAINTENANCE 12-16 STORAGE 17 TROUBLESHOOTING 18 WARRANTY 20-23 KNOW YOUR SNOW THROWER READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with your snow thrower
  • Husqvarna ST 151 | Owners Manual - Page 5
    Use the chart below to verify that all parts have been shipped. Description Qty. Carriage bolts 4 Shoulder Bolt 1 Flange handle and feed the recoil rope through the rope guide. 1 2 3 4 Figure 4 1. Handle 2. Recoil handle 3. Rope guide 4. Adjustment lever nut 6. Snap two rotator cables
  • Husqvarna ST 151 | Owners Manual - Page 6
    2 3 9 6 3 2 ENGINE See engine manual. LUBRICATION NOTE: SAE 10W30 or SAE 5W30 oil is acceptable for use in cold temperatures if engine is oil. Change the oil after every 25 hours of operation or at least once a year if the snow thrower is not used for 25 hours in one year. Check the crankcase oil
  • Husqvarna ST 151 | Owners Manual - Page 7
    94 11 16 3 17 8 *7 6 5 15 Figure 8 1. Discharge chute 2. Chute deflector 3. Fuel tank cap 4. Primer 5. Electric-start button (if equipped) 6. Oil drain plug 7. Oil fill cap/dipstick 8. Choke lever 9. Ignition key 10. Chute rotator handle 11. Recoil start handle 12. Control bar 13. Lights 14
  • Husqvarna ST 151 | Owners Manual - Page 8
    tip the snowthrower with fuel in the fuel tank. The operation of any snow thrower can result in foreign objects thrown into the eyes, which can result in gasoline (minimum 87 AKI octane rating) (Figure 9). Checking the Engine Oil Level 1. Move the snowthrower to a level surface. 2. Clean around
  • Husqvarna ST 151 | Owners Manual - Page 9
    (Figure 12) or if your snow thrower is equipped with an electric starter, connect an extension cord to the snow thrower and plug the other end into the second series of attempts, take the snowthrower to an Authorized Service Dealer for service. NOTE: If you pull the recoil handle and feel no
  • Husqvarna ST 151 | Owners Manual - Page 10
    operation there may be wear between the auger blades and the scraper bar. Maximum performance, both snow throwing and driving, occurs when there is zero clearance between these two parts (Figure 16). Adjusting the Discharge Chute and Chute Deflector 1. To adjust the discharge chute, rotate chute
  • Husqvarna ST 151 | Owners Manual - Page 11
    difficulty operating any control or part, start the engine and let it run for a few minutes. Operating Tips Clearing a Clogged Discharge Chute Hand contact with the rotating auger blades inside the discharge chute is the most common cause of injury associated with snow throwers. Never use your hand
  • Husqvarna ST 151 | Owners Manual - Page 12
    normal operating position. Check for Loose Fasteners Clean / Inspect Snow Thrower Clean / Replace V-Belts Check / Replace Auger Blades and Scraper Bar Check Fuel Lines and Electrical Wires Check Engine Oil Level Change Engine Oil Inspect Muffler Check / Replace Spark Plug Empty Fuel Tank Adjusting
  • Husqvarna ST 151 | Owners Manual - Page 13
    fill cap/dipstick line (Figure 26). Max fill: 18 oz. (0.5 l), type: automotive detergent oil with an API service classification of SJ, SL, or higher. Fill if oil is below "Add" on the GLSVWLFN 1 Figure 24 1. Oil drain plug Fill if oil is below letter "L" on the ¿OOHUFDS Figure 26 10. Screw in the
  • Husqvarna ST 151 | Owners Manual - Page 14
    Servicing the Spark Plug Use a NGK BPR6ES, Champion RN9YC, or BOSCH WR6DC spark plug or equivalent. 1. Move snow thrower to a level surface. 2. Run snow thrower set top cover to the side of the unit. 10. Temporarily reinstall oil fill cap to prevent foreign object from entering the engine. 11. Remove
  • Husqvarna ST 151 | Owners Manual - Page 15
    covers and into the clip on the side cover (Figure 28). 24. Remove top oil fill cap. 25. Set top cover in place and snap three top cover clips into the rear upper cover (Figure 29). 26. Reinstall top oil fill cap. 27. Reinstall two screws in the side covers that attach to the
  • Husqvarna ST 151 | Owners Manual - Page 16
    Belt If auger v-belt becomes worn, oil-soaked, excessively cracked, frayed, or otherwise damaged, replace the belt. 1. Remove the drive side cover by removing the six screws as shown in (Figure 34). 5 4 6 7 4. Install the new auger v-belt Engine pulley 7. Auger V-Belt 2. Remove drive pulley
  • Husqvarna ST 151 | Owners Manual - Page 17
    in a clean, dry area. 1. Clean entire snow thrower after each use. 2. Inspect and replace belts, if necessary (See "Replaceing the Drive Belt" section of this manual). 3. Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace
  • Husqvarna ST 151 | Owners Manual - Page 18
    TROUBLESHOOTING Troubleshooting See appropriate section in manual unless directed to a service center/department. PROBLEM CAUSE CORRECTION Does not start 1. Safety ignition key is not inserted. 1. Insert safety ignition key. 2. Out of fuel. 2. Fill fuel tank with fresh, clean gasoline. 3.
  • Husqvarna ST 151 | Owners Manual - Page 19
    SERVICE NOTES 19
  • Husqvarna ST 151 | Owners Manual - Page 20
    , such as throttle cable, belt guides adjustments; and c. Preventative maintenance as outlined in the operator's manual. In addition, you must cease using the product immediately upon any failure or damage. The product should be taken to an authorized Husqvarna servicing dealer prior to any further
  • Husqvarna ST 151 | Owners Manual - Page 21
    contains a maximum 10% ethanol (grain alcohol) is approved. The prescribed mixing ratio of gasoline to oil is 50:1 and is listed in the Husqvarna oil label and covered in your operator's manual. (h) Use of ether or any starting fluids; (i) Pressure cleaning or steam cleaning the product; (j) Use
  • Husqvarna ST 151 | Owners Manual - Page 22
    , other than Rental Use) No Warranty * Transmission (if made by Husqvarna/Peerless) Transmission (if third party)** XLS Models only - stamped deck Pro-rated 3 Years No Warranty 1 Year Pro-rated 1 Year Snow Throwers, Tillers, LE475 Edger Engine* Auger Gearbox Other Non-Expendable Components Tiller
  • Husqvarna ST 151 | Owners Manual - Page 23
    Parts (e.g., belts, blades, etc.) 90 days No Warranty No Warranty Parts & Accessories (if replaced in Warranty Service) Replacement parts specific Snow Throwers & Tillers, warranty through Husqvarna. ** See reference 4 (b) of the warranty statement. RZ - Two (2) Year Consumer warranty, parts
  • Husqvarna ST 151 | Owners Manual - Page 24
    07/09/2014 TH/AP
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
English
115 68 51-27
Operator’s Manual
ST 151
Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
Please read the owner's manual carefully and make sure you
understand the instructions before using the machine.