IBM 84885BU User Manual - Page 100
Removing, system, board
View all IBM 84885BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Removing the system board Before you begin: v Read Appendix B, "Safety information," on page 143. v Review the information in "System reliability guidelines" on page 25. Notes: 1. When replacing the system board, you must either update the server with the latest firmware or restore the pre-existing firmware that the customer provides on a diskette or CD image. 2. Removing the system board will be easier if the server is turned on its side. To remove the system board, complete the following steps: 1. Turn off the server, if it is on. 2. Disconnect the power cord from the power source and from the server; then, disconnect all external cables. 3. Remove the side cover (see "Removing the side cover" on page 28). 4. Remove the frame-support bracket (see "Removing and installing the support bracket" on page 32). 5. Remove the microprocessor air baffle (see "Microprocessor air baffle" on page 67). 6. Disconnect the cables. 7. Remove both adapter-retaining brackets and the adapters (see "Installing an adapter" on page 51). 8. Remove memory modules (see "Installing a memory module" on page 34). 9. Remove the microprocessors (see "Microprocessor and heat sink" on page 68). 10. Remove the VRM if one is installed (see "Installing an additional microprocessor" on page 46 for the location of the VRM). 11. Remove the front fan housing. 90 xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide