IBM 84885BU User Manual - Page 19
Configuring, server
View all IBM 84885BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Chapter 2. Configuring the server Detailed information about configuring the server is in the IBM xSeries User's Guide on the IBM Documentation CD. The latest information about these programs and the most recent device-driver files are available at http://www.ibm.com/pc/support. The following configuration programs and capabilities come with the server: v Configuration/Setup Utility program The Configuration/Setup Utility program is part of the basic input/output system (BIOS) code in the server. Use it to configure serial port assignments, change interrupt request (IRQ) settings, change the startup-device sequence, set the date and time, and set passwords. v IBM ServerGuide Setup and Installation CD The ServerGuide program provides software-setup tools and installation tools that are designed for the server. v Boot Menu program The Boot Menu program is part of the BIOS code in the server. Use it to temporarily assign a device to be first in the startup sequence, overriding the startup sequence that is set in the Configuration/Setup Utility program. v Ethernet controller configuration The Ethernet controller is integrated on the system board. You do not need to set any jumpers or configure the controller. However, you must install a device driver. For device drivers and information about configuring the Ethernet controller, see the Broadcom NetXtreme Gigabit Ethernet Software CD that comes with the server. For updated information about configuring the controller, go to http://www.ibm.com/pc/support/. v Adaptec® HostRAID™ configuration programs Note: The device drivers required to enable HostRAID must be downloaded from the IBM Web site at http://www.ibm.com/pc/support. - Adaptec RAID Configuration Utility programs (for Serial ATA RAID) Use the Array Configuration Utility within the Adaptec RAID Configuration Utility programs to configure RAID for the integrated Serial ATA (SATA) controller and the devices that are attached to it. - SCSISelect Utility program (for SCSI RAID) Use the SCSI HostRAID feature of SCSISelect Utility program to configure RAID for the SCSI controller and the devices that are attached to it. v ServeRAID Manager ServeRAID Manager is available as a stand-alone program and as an IBM Director extension. If a ServeRAID adapter is installed in the server, use ServeRAID Manager to define and configure the disk-array subsystem before you install the operating system. v SCSISelect Utility program (some models) For general configuration, use the SCSISelect Utility program to configure devices that are attached to the SCSI controller. © Copyright IBM Corp. 2004 9