IBM 84885BU User Manual - Page 91
Power/LED, switch, assembly
View all IBM 84885BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Power/LED switch assembly Before you begin: v Read the "Installation guidelines" on page 25. v Read Appendix B, "Safety information," on page 143. v Review the information in "System reliability guidelines" on page 25. To remove the power/LED switch assembly, complete the following steps: 1. Turn off the server, if it is on. 2. Disconnect the power cord from the power source and from the server; then, disconnect all external cables. 3. Lay the server on its side. 4. Remove the side cover (see "Removing the side cover" on page 28). 5. Remove the front bezel (see "Removing the bezel" on page 30). 6. On a SCSI model, remove all drives and filler panels from the drive cage; on a SATA model, remove the bezel filler. 7. Press the cage-release latch toward the bottom of the server, and rotate the drive cage outward until it locks in the vertical position, so that you can reach through to the other side of the power-switch and LED-panel cable. 8. To remove the power-switch and LED panel, from the outside of the server front press in on the tab on the left side of the panel; then, squeeze the top and bottom of the right side of the panel and carefully pull the panel away from the server. 9. Press upward on the amber LED to remove it from the power-switch and LED panel bracket; then, thread the LED back into the server and out the same opening as the other power-switch and LED-panel wires. Chapter 5. Field replaceable units 81